• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-03-26 14:39来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 -do the wet motoring of the APU until fuel coming out of the fuel supply tube free of preservation fluid.
 -let the fuel flow into a CONTAINER 10 L(2 1/2 USGAL). NOTE : To cancel motoring cycle, push the APU MASTER SW p/bsw to
____
 the OFF position.

 (9) Open, safety and tag this(these) circuit breaker(s):
 1KD, 2KD.

 (10)
 Connect the fuel supply to the flow divider.

 (11)
 Replace the fuel filter element (Ref. TASK 49-32-11-610-002).

 (12)
 Connect the electrical connector P10 to the ignition unit (Ref. TASK 49-41-38-400-002).

 (13)
 Remove the tag indicating that the fuel system has been preserved.

 (14)
 Remove the WARNING NOTICE in the cockpit.

 (15)
 Perform an operational check of the APU (Ref. TASK 49-00-00-710-008) . During the check select bleed load to actuate the IGV actuator and BCV and check the engine for any fuel, oil or air leaks.


 5. Close-up
________ Subtask 49-20-00-410-069
 A. Close Access
 (1)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (2)
 Set the LIGHT control SW 11LJ to the OFF position.

 (3)
 Close the APU access doors 315AL and 316AR (Ref. TASK 52-41-00-410-001).

 (4)
 Remove the access platform(s).

 


 (5)
 Remove the warning notice(s). Subtask 49-20-00-865-087

 B.
 Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 1KD, 2KD.


 Subtask 49-20-00-860-078
 C. Aircraft Maintenance Configuration.
 (1) De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002).


 ENGINE ((GTCP 36-300)) - INSPECTION/CHECK
_________________________________________

R **ON A/C 001-003, 051-099, 401-499,
 TASK 49-20-00-200-001
 Inspection/Check of the Engine (4005KM) (GTCP 36-300)
 WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL MATERIALS
_______
 ONLY WITH A GOOD SUPPLY OF AIR.
 OBEY THE MANUFACTURERS INSTRUCTIONS.
 PUT ON PROTECTIVE CLOTHING.
 DO NOT GET THEM IN YOUR MOUTH.
 DO NOT SMOKE.
 DO NOT BREATHE THE GAS.
 THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT.
 GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.

 WARNING : DO NOT TOUCH THE APU UNTIL IT IS SUFFICIENTLY COOL TO PREVENT BURNS
_______
 WHEN YOU DO THE MAINTENANCE TASK(S).

 WARNING : DISCONNECT THE LOW TENSION ELECTRICAL SUPPLY 5 MINUTES BEFORE YOU
_______ START WORK ON THE IGNITION SYSTEM. ALSO, GROUND THE IGNITER LEAD WITH AN INSULATED DEVICE AS YOU DISCONNECT IT FROM THE IGNITER PLUG. HIGH CURRENT AND VOLTAGE, WHICH ARE USED IN THE IGNITION SYSTEM, CAN KILL YOU.
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific boroscope 6/8/mm
 No specific circuit breaker(s) safety clip(s)
 No specific light source, Olympus 1LK-2
 No specific socket spanner 0.3125 in. (7.9374 mm)
 No specific access platform 3.0 m (9 ft. 10 in.)
 98D49207534000 1 GUIDE TOOL - BORESCOPE, APU

 

 B. Consumable Materials
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 11-004 USA MIL-T-81533
 1.1.1TRICHLOROETHANE (METHYL CHLOROFORM)
 (Ref. 20-31-00)
 C. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
49-00-00-860-003 49-00-00-860-004 49-23-51-000-002 49-32-11-210-001 49-41-41-000-001 49-41-41-400-001 49-72-15-000-003 49-72-15-400-001 49-91-00-210-001 52-41-00-010-001 52-41-00-410-001  APU Start by External Power (GTCP 36-300)APU Shutdown by External Power (GTCP 36-300)Removal of the Inlet Guide Vane-Actuator (8014KM) (GTCP 36-300)Inspection of the Fuel-Filter Differential-Pressure Indicator (GTCP 36-300)Removal of the Igniter Plug (8031KM) (GTCP 36-300)Installation of the Igniter Plug (8031KM) (GTCP 36-300)Removal of the Thermocouple Probes (8057KM1) and (8057KM2) (GTCP 36-300)Installation of the Thermocouple Probes (8057KM1) and (8057KM2) (GTCP 36-300)Check Lube and Alternator-Scavenge Filter Differential Pressure Indicator Position (Pop out not protruding) (GTCP 36-300)Open the APU Doors for AccessClose the APU Doors after Access
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM 机载辅助动力 AIRBORNE AUXILIARY POWER3(80)