(6)
AMM 31-51-00/501, MAWEA
(7)
AMM 31-61-00/501, Integrated Display System
(8)
AMM 32-09-02/201, Air/Ground Relay System
(9)
AMM 34-61-02/401, Control Display Unit
(10)
AMM 45-10-00/501, Central Maintenance Computer System
B. Access
(1)
Location Zone 117 Electrical and Electronics Compartment 138 Body Landing Gear Well, RH 221/222 Flight Compartment 273 Area Above Ceiling
(2)
Access Panel 117AL E/E Compartment Access Door 751 Body Landing Gear Door, Aft Inboard Large access door on left side of Door 5 Overhead Crew Rest
Area (airplanes with crew rest area) Hinged Ceiling Panel (airplanes without crew rest area)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
31-31-00
ALL ú ú 01 Page 505 ú Feb 15/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
C.
D.
E.
A
747-400 MAINTENANCE MANUAL
Preconditions
S 865-095
(1) These conditions are necessary for this task:
(a)
HF Communication System, serviceable (AMM 23-11-00/501).
(b)
VHF Communication System, serviceable (AMM 23-12-00/501).
(c)
Electrical power on (AMM 24-22-00/201).
(d)
MAWEA, serviceable (AMM 31-51-00/501).
(e)
Integrated Display System (IDS), serviceable
(AMM 31-61-00/501).
(f)
CDU installed (AMM 34-61-02/401).
(g)
Central Maintenance Computer System (CMCS), serviceable
(AMM 45-10-00/501).Prepare for the System Test
S 865-007
(1) Supply electrical power (AMM 24-22-00/201).
S 865-075
WARNING: YOU MUST CAREFULLY FOLLOW THE STEPS IN THE TASK BELOW TO
_______ PREPARE THE SAFETY SENSITIVE SYSTEMS FOR THE AIR MODE. FAILURE TO FOLLOW THE STEPS CORRECTLY CAN CAUSE THE AUTOMATIC OPERATION OF THE AIRPLANE SYSTEMS. THIS CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
(2) Do the "Prepare Safety-Sensitive Systems for Air Mode Simulation" task (AMM 32-09-02/201).
NOTE: Do not open the FLT RCDR AC or FLT RCDR DC circuit breakers
____
when you do this task.
S 865-010
(3)
Get access to the CMC INPUT MONITORING menu on a CDU.
(a)
Push the MENU key on a CDU.
(b)
Push the LSK adjacent to the <CMC prompt.
(c)
Push the LSK adjacent to the <OTHER FUNCTIONS prompt.
(d)
Push the LSK adjacent to the <INPUT MONITORING prompt.Procedure
S 735-076
(1)
Do a test of the air/ground relay discrete
(a) Set the CMC to show octal label 270, SDI 00 from CMC port 20 in binary (C/20/270/00).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
31-31-00
ALL ú ú 01 Page 506 ú Oct 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
WARNING: MAKE SURE YOU HAVE PREPARED THE AIRPLANE FOR THE AIR MODE
_______ BEFORE YOU OPEN THE CIRCUIT BREAKER THAT FOLLOWS. AUTOMATIC OPERATION OF AIRPLANE SYSTEMS IN THE AIR MODE CAN CAUSE INJURY OR DAMAGE.
(b)
Open this circuit breaker:
1) P7, Overhead Circuit Breaker Panel
a) 7H8, GND SAFETY RLY
(c)
Make sure bit 27 is set to a 0.
(d)
Close this circuit breaker:
1) P7, Overhead Circuit Breaker Panel
a) 7H8, GND SAFETY RLY
(e)
Make sure that bit 27 changes to a 1 after approximately 5 minutes.
S 735-158
(2) Do a test of the VHF keyline discrete:
(a)
Tune the VHF transceivers to an approved test frequency.
(b)
Set the CMC to show octal label 270, SDI 00 from CMC port 20 in binary (C/20/270/00).
(c)
Do a test of the VHF-L keyline discrete: 1) Push the MIC CALL switch for VHF-L on an Audio Control
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：747-400 AMM 飞机维护手册 指示/记录系统 1(52)
