(3)
AMM 31-51-00/501, MAWEA
(4)
AMM 31-61-00/501, Integrated Display System
(5)
AMM 34-61-02/401, Control Display Unit
(6)
AMM 45-10-00/501, Central Maintenance Computer System
B. Access
(1) Location Zones 116 Area Between Nose Wheel Well and Fuselage-RH 221 Control Cabin, LH 222 Control Cabin, RH
C. Preconditions
S 865-093
(1) These conditions are necessary for this task:
(a) Electrical power on (AMM 24-22-00/201).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
31-31-00
ALL ú ú 01 Page 501 ú Jun 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
(b)
MAWEA serviceable (AMM 31-51-00/501).
(c)
Integrated Display System (IDS), Serviceable (31-61-00/501).
(d)
CDU installed (AMM 34-61-02/401).
(e)
Central Maintenance Computer System (CMCS), serviceable (AMM 45-10-00/501).
D. Flight Data Recorder and DFDAC Operational Test
S 865-002
(1)
Supply electrical power (AMM 24-22-00/201).
S 745-074
(2)
Do this task: Ground Test - Flight Recorder System
(AMM 31-31-00/501).
(a)
During the ground test, make sure that the red and yellow LEDs on the DFDAC come on.
(b)
When the test is completed, make sure that PASS shows adjacent to the FLIGHT RECORDER selection on the CDU.
(c)
Make sure the red and yellow LEDs go off after approximately 20 seconds.
E. Accelerometer Operational Test
S 865-098
(1) Get access to the CMC Input Monitoring function on a CDU:
(a)
Push the MENU key on the CDU.
(b)
Push the line select key adjacent to <CMCS.
(c)
Push the line select key adjacent to <OTHER FUNCTIONS.
(d)
Push the line select key adjacent to <INPUT MONITORING.
S 715-099
(2) Do a test of the vertical acceleration signal:
(a)
Put C/020/340/00 into the scratchpad with the CDU keys.
(b)
Push the upper left line select key.
(c)
Push the line select key adjacent to HEX>.
(d)
Make sure that the display shows a value between X73E0007 and X7B10007 (where X can be all hexadecimal characters).
NOTE: If you do not get a correct value, make sure that the
____ airplane is level. The airplane must be level with a tolerance of 0.25 degrees. Use a plumb-bob or an equivalent tool to make sure that the airplane is level.
S 715-100
(3) Do a test of the lateral acceleration signal:
(a)
Put C/020/341/00 into the scratchpad with the CDU keys.
(b)
Push the upper left line select key.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
31-31-00
ALL ú ú 01 Page 502 ú Oct 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
(c) Make sure that the display shows a value between X8180087 and X88C0087 (where X can be all hexadecimal characters).
S 715-101
(4) Do a test of the longitudinal acceleration signal:
(a)
Put C/020/343/00 into the scratchpad with the CDU keys.
(b)
Push the upper left line select key.
(c)
Make sure that the display shows a value between X81800C7 and X88C00C7 (where X can be all hexadecimal characters).
TASK 31-31-00-745-090
3. Ground Test - Flight Recorder System____________________________________
A. General
(1) The CMCS ground test of the Flight Recorder System puts the Digital Flight Data Acquisition Card (DFDAC) into the test mode. When the DFDAC completes it test, it sends the results back to the CMC. The test includes a BITE test of the Digital Flight Data Recorder (DFDR).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：747-400 AMM 飞机维护手册 指示/记录系统 1(50)
