曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
NOTE:
On SPZ-8400 equipped aircraft, BTMS is incorporated
in the BRAKES system page.
20. Transponder ..........................................................................................STANDBY
21. GPWS/GND SPLR FLAP ORIDE....................................................................OFF
22. Trim Settings (3) .............................................................................................SET
23. Takeoff Briefing.........................................................................ACCOMPLISHED
OPERATING MANUAL
EXPANDED NORMAL PROCEDURES 03-07-00
Page 1
May 31/01
Revision 4
24. FMS ..................................................................................................................SET
25. Flight Instruments ..........................................................................................SET
26. Guidance Panel...............................................................................................SET
27. WARN INHIBIT...........................................................................................INHIBIT
28. Flight Observer Seat Position .................................................................CHECK
LINE UP
29. Cowl Anti-Ice (2) / Wing Anti-Ice (2) ...........................................AS REQUIRED
30. Exterior Lights ................................................................................................SET
31. Transponder......................................................................................................ON
32. Radar..............................................................................................AS REQUIRED
33. Ground Spoilers .......................................................................................ARMED
34. V-Speeds...............................................................................CHECKED / BOXED
35. EICAS ....................................................................................................CHECKED
OPERATING MANUAL
03-07-00 EXPANDED NORMAL PROCEDURES
Page 2
May 31/01
Revision 4
ALTERNATE NORMAL PROCEDURES
03-08-10: Cold Start
In cold ambient temperatures (when oil temperature is -10°C or less), refer to Section
07-01-20, Cold Weather Operations.
CAUTION
IF DEICING SOLUTION IS INADVERTENTLY
SPRAYED INTO THE ENGINE INLETS OR APU
INLETS, OR CONTACTS THE EXHAUST WHEN
ENGINES OR APU ARE OPERATING, POTENTIALLY
UNSAFE CONDITIONS COULD DEVELOP IN THE
CABIN. ENGINE / APU BLEEDS SHOULD BE
CLOSED DURING DEICING OPERATIONS TO
MINIMIZE THE RISK OF CABIN ENVIRONMENT
CONTAMINATION.
03-08-20: External Air Start
1. External Air Source.........................................................................CONNECTED
2. Normal Engine Start ............................................................................PERFORM
Either engine, or both in turn, may be started using an external air source.
NOTE:
Engine start cycle times may vary depending on the
source of external air.
03-08-30: Crossbleed Start
AFTER STARTING ONE ENGINE FROM EITHER APU OR AN EXTERNAL AIR
SUPPLY:
1. Bleed Air (Engine To Be Started)..................................................................OFF
2. Bleed Air (Operating Engine) ..........................................................................ON
3. Running Engine Power Lever ..............ADVANCE TO ACHIEVE 25 TO 30 PSI
MINIMUM BLEED AIR PRESSURE
Bleed air pressure may be determined using the indicator on the overhead panel
or ENGINE START synoptic page.
4. Engine Not Running .............START USING NORMAL START PROCEDURES
AFTER STARTING OTHER ENGINE:
5. Power Levers .................................................................................................IDLE
6. Bleed Air ........................................................................................AS REQUIRED
03-08-40: Engine Cranking Cycle
1. HP Fuel Cock................................................................................................SHUT
2. Power Lever ...................................................................................................IDLE
3. APU Air / Bleed Air...........................................................................................ON
4. Boost Pump ......................................................................................................ON
OPERATING MANUAL
EXPANDED NORMAL PROCEDURES 03-08-00
Page 1
May 30/02
Revision 7
5. Engine Crank Master .......................................................................................ON
6. Engine Start Switch .........................................................................................ON
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
湾流4操作手册 Gulfstream IV Operating Manual 3(40)
