NOTE: This test uses gravity to check the drain piping and
____ toilet tank components for leaks.
(2)
Test Methods:
(a)
Pressurize the cabin to test the waste system components.
(b)
Use the vacuum fixture to test the waste system components.
(3)
Operational Tests:
(a)
Make sure the toilet flushing components operate correctly.
(b)
Operational test of the check valve for the flush line to the toilet tank.
TASK 38-32-00-795-100
2. Toilet Tank Dump Valve Leak Test (Fig. 501)
________________________________
A. General
(1) This test examines the toilet tank dump valve for leaks. You must repeat this test for each toilet on the airplane.
B. References
(1)
AMM 12-17-00/301, Toilet Servicing
(2)
AMM 38-32-31/401, Toilet Drain Valve
(3)
AMM 38-32-51/401, Toilet Waste Tank
C. Equipment
(1) Gloves - Rubber (elbow length)
D. Access
(1) Location Zones
103 Forward Lavatory
113 Left Aft Lavatory
114 Right Aft Lavatory (if installed)
118 Lavatory (if installed)
205 Electronic Compartment
218 Aft Cargo Compartment
E. Procedure
S 615-091
(1)
Do the servicing procedure for the toilet tank but drain the chemical precharge after five minutes (AMM 12-17-00/301).
(2)
Do not close the service panel drain valve.
S 865-160
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
38-32-00
ALL ú ú 01 Page 501 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
(3) S 415-019Close the toilet tank dump valve.
NOTE:____ Let the dump valve handle move suddenly into the closed position to make sure there is a positive seat for the valve.
(4) S 865-017Fill the toilet tank with approximately 10 gallons of water.
(5) S 015-096Remove the toilet tank shroud.
(6) S 015-093On toilet systems with the ball valve, do these steps to open the ball valve: (a) Disconnect the tank dump valve cable from the ball valve cable. (b) Use the cable handle at the service panel to pull the ball valve open.
(7) S 215-027Examine the flush line and flush line connections for leaks. (a) Tighten any clamps that are loose and replace any lines or connectors that have damage.
(8) S 215-028Examine the service panel for leakage. (a) If you find leakage, do these steps: 1) Drain the toilet tank and keep the tank dump valve open. 2) Look through the bottom of the toilet bowl and locate the tank outlet. 3) Look for and remove the debris that does not let the tank dump valve close correctly. 4) If no debris is present, close the tank dump valve.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
38-32-00
ALL ú ú 01 Page 502 ú Mar 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
5) Make sure the cable for the tank dump valve is adjusted correctly and can move freely. 6) If the cable is satisfactorily installed, replace the tank dump valve (AMM 38-32-31/401). 7) Examine the bottom of the rubber boot on the valve for damage. 8) If the rubber boot is damaged, replace the tank dump valve (AMM 38-32-31/401). 9) Feel the tank outlet surface that makes a seal with the valve for chips, cracks and roughness.
NOTE: Use rubber gloves with long sleeves.
____
10) If the tank outlet is damaged, replace the tank (AMM 38-32-51/401).
F. Return the Airplane Back to Its Usual Condition
S 425-098
(1)
On toilet systems with the ball valve, connect the tank dump valve cable to the ball valve cable.
S 415-095
(2)
Install the toilet shroud.
S 615-163
(3)
Service the toilet but ignore the steps that flush the tank with 8 gallons of water (AMM 12-17-00/301).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-300 400 500 AMM 飞机维护手册 WATER AND WASTE(44)
