(3)
Remove the access platform(s).
(4)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
1EFF : ALL 1 32-42-16Page 419 1 1 May 01/05R 1 1 1CES 1
TASK 32-42-16-000-002
Removal of the Normal-Brake Servovalve Manifold Filter
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s)
No specific safety barriers
No specific warning notice
No specific access platform 2.5 m (8 ft. 2 in.)
No specific container 5 l (1.3208 USgal)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
29-00-00-864-001 Put the Related Hydraulic System in the Depressurized
Configuration before Maintenance Action 29-14-00-614-001 Depressurization of the Hydraulic Reservoirs 29-23-00-860-001 Disconnection of the Isolation Coupling of the Power
Transfer Unit (PTU) 32-00-00-481-001 Installation of the Safety Devices on the Landing Gears
1EFF : ALL 1 32-42-16Page 420 1 1 Nov 01/04R 1 1 1CES 1
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
R **ON A/C 001-002, 051-052,
32-42-16-991-003 Fig. 403
**ON A/C ALL
R Post SB 32-1190 For A/C 001-002,051-052, 32-42-16-991-004 Fig. 404 **ON A/C ALL
3. Job Set-up
__________ R **ON A/C 001-002, 051-052,
(Ref. Fig. 403/TASK 32-42-16-991-003)
**ON A/C ALL
Subtask 32-42-16-941-052
A. Safety Precautions
(1)
Put the safety barriers in position.
(2)
Make sure that the ground safety locks are installed on the landing gear (Ref. TASK 32-00-00-481-001).
(3)
On the panel 400VU:
-make sure that the landing-gear control-lever 6GA is in the DOWN position
-put a warning notice in position in the cockpit to tell persons not to operate the landing gear.
(4)
Put a warning notice on the ground service connection to tell persons not to pressurize the Green hydraulic system.
1EFF : ALL 1 32-42-16Page 421 1 1 May 01/05 1 1 1CES 1
Normal-Brake Servovalve Manifold Filter Installation Detail
Figure 403/TASK 32-42-16-991-003
R 1EFF : 001-002, 051-052, 1 32-42-16Page 422 1 1 May 01/05 1 1 1CES 1 Subtask 32-42-16-860-053
B. Aircraft Maintenance Configuration
WARNING : OBEY THE HYDRAULIC SAFETY PROCEDURES.
_______
(1)
Make sure that the Green hydraulic system is depressurized (Ref. TASK 29-00-00-864-001).
(2)
Depressurize the Green hydraulic reservoir (Ref. TASK 29-14-00-614-001).
Subtask 32-42-16-865-053
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU HYDRAULIC/BRAKING AND STEERING/SYS2/SPLY 4GG M36 121VU HYDRAULIC/BRAKING AND STEERING/SYS2/CTL 3GG M35 121VU HYDRAULIC/BRAKING AND STEERING/SYS1/CTL 1GG M34 121VU HYDRAULIC/BRAKING AND STEERING/SYS1/IND AND/SPLY 2GG M33 121VU HYDRAULIC/G HYD/PUMP ENG1/MONG 1702GK R34
Subtask 32-42-16-010-052
D. Get Access
(1)
Put an access platform below the applicable normal-brake servovalve manifold assembly:
-
FOR 2613GM
below zone 731
-
FOR 2612GM
below zone 741.
(2)
Put a container below the applicable normal-brake servovalve manifold assembly.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM LANDING GEAR 起落架7(8)
