(2)
Depressurize the reservoir of the Green hydraulic system. (Ref. TASK 29-14-00-614-001).
(3)
Put a WARNING NOTICE in position to tell persons not to pressurize the Green hydraulic system: - on the panel 40VU in the cockpit - on the ground service panel of the Green hydraulic system.
(4)
Put a CONTAINER 3 L(3/4 USGAL) below the normal-brake supply pressure-transducer (10) to collect the hydraulic fluid leakage.
Subtask 32-42-22-865-050
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU HYDRAULIC/BRAKING AND STEERING/SYS2/SPLY 4GG M36 121VU HYDRAULIC/BRAKING AND STEERING/SYS2/CTL 3GG M35 121VU HYDRAULIC/BRAKING AND STEERING/SYS1/CTL 1GG M34 121VU HYDRAULIC/BRAKING AND STEERING/SYS1/IND AND/SPLY 2GG M33 121VU HYDRAULIC/G HYD/PUMP ENG1/CTL 1701GK R35 121VU HYDRAULIC/G HYD/PUMP ENG1/MONG 1702GK R34
1EFF : 401-499, 1 32-42-22Page 402 1 1 Aug 01/05 1 1 1CES 1
4. Procedure
_________ Subtask 32-42-22-020-050
A. Removal of the Pressure Transducer (96GG)
(Ref. Fig. 401/TASK 32-42-22-991-001)
(1)
Obey the hydraulic safety procedures (Ref. TASK 29-00-00-910-002).
(2)
Disconnect the electrical connector (9).
(3)
Put blanking caps on the disconnected electrical connectors.
(4)
Remove the nut (8), the bolt (4), the washer (5) and the bonding strap (6) from the clamp (7).
(5)
Remove the clamp (7) from the pressure transducer (10).
(6)
Hold the pressure transducer (10) and remove the bolts (3) and the washers (2).
(7)
Remove the pressure transducer (10) from the manifold (1).
(8)
Install the CAP - BLANKING in the open ports of the pressure transducer (10) and the manifold (1).
1EFF : 401-499, 1 32-42-22Page 403 1 1 Aug 01/05 1 1 1CES 1
Normal-Brake Supply Pressure-Transducer
Figure 401/TASK 32-42-22-991-001
1EFF : 401-499, 1 32-42-22 Page 404
1 1 Aug 01/05
1 1
1CES 1
TASK 32-42-22-400-001
Installation of the Normal-Brake Supply Pressure-Transducer (96GG)
WARNING : MAKE SURE THAT ALL THE CIRCUITS IN MAINTENANCE ARE ISOLATED BEFORE
_______ YOU SUPPLY ELECTRICAL POWER TO THE AIRCRAFT.
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : OBEY THE HYDRAULIC SAFETY PROCEDURES.
_______
WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL MATERIALS
_______ ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific 1 ACCESS PLATFORM 2M (6 FT)
No specific 1 CONTAINER 3 L(3/4 USGAL)
No specific Torque Wrench : range 0.00 to 1.20 m.daN
(0.00 to 9.00 lbf.ft)
1EFF : 401-499, 1 32-42-22Page 405 1 1 Aug 01/05 1 1 1CES 1
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 05-002 USA MIL-P-8116 PUTTY, ZINC CHROMATE GENERAL PURPOSE (Ref. 20-31-00)
Material No. 09-013 USA MIL-PRF-81733 TYPE I CLASS A CORROSION INHIBITING BRUSH CONSISTENCY (Ref. 20-31-00)
Material No. 16-021 F ASNB70720 FLEXIBLE POLYURETHANE (Ref. 20-31-00)
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM LANDING GEAR 起落架7(14)
