TASK 29-22-00-860-001
Installation of the Safety Device of the Ram Air Turbine WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
1. Reason for the Job
__________________
To prevent accidental deployment of the Ram Air Turbine (RAT).
When you work near the RAT, you must install the RAT safety device.
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s) No specific warning notices 98D29207542000 1 SAFETY DEVICE - RAT
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
29-22-00-991-004 Fig. 203
3. Job Set-up
__________ Subtask 29-22-00-941-074
A. Put the warning notices in position to tell persons not to operate the RAT: - on the overhead panels 21VU and 40VU.
R 1EFF : 001-049, 051-061, 101-105, 201-203, 1 29-22-00Page 224 1 1 Config-1 May 01/05 1 1 1CES 1 Subtask 29-22-00-865-083
B. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------106VU CSM/G /EV/MAN/SPLY 6XE B04 121VU HYDRAULIC/RAT/SPLY/EXTN/SOL1 2803GE P33
R **ON A/C 001-049, 051-061, 101-102, 201-202,
121VU HYDRAULIC/RAT/CTL 2801GE P32 R **ON A/C 103-105, 203-203,
121VU HYD/RAT/CTL 2801GE P32 R **ON A/C 001-049, 051-061, 101-105, 201-203,
Subtask 29-22-00-010-069
C. Open the access door 195BB.
4. Procedure
_________
Subtask 29-22-00-481-050
A. Installation of the Safety Device
(Ref. Fig. 203/TASK 29-22-00-991-004)
(1)
Put the safety block (5) SAFETY DEVICE - RAT (98D29207542000) in position between the RAT (1) and the aircraft structure (2).
(2)
Put the thrust block (4) in position against the aircraft structure
(2) and tighten the screw (3).
(3)
Make sure that the signal flag (6) hangs outside of the aircraft so that you can clearly see it.
R 1EFF : 001-049, 051-061, 101-105, 201-203, 1 29-22-00Page 225 1 1 Config-1 May 01/05 1 1 1CES 1
Installation of the RAT Safety Device
Figure 203/TASK 29-22-00-991-004
R 1EFF : 001-049, 051-061, 101-105, 201-203, 1 29-22-00Page 226 1 1 Config-1 May 01/05 1 1 1CES 1
TASK 29-22-00-860-002 Removal of the Safety Device of the Ram Air Turbine
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
98D29207542000 1 SAFETY DEVICE - RAT
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
29-22-00-991-004 Fig. 203
3. Job Set-up
__________ Subtask 29-22-00-941-075
A. Make sure that the warning notices are in position to tell persons not to operate the RAT: - on the overhead panels 21VU and 40VU.
R 1EFF : 001-049, 051-061, 101-105, 201-203, 1 29-22-00Page 227 1 1 Config-1 May 01/05 1 1 1CES 1 Subtask 29-22-00-865-084
B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------106VU CSM/G /EV/MAN/SPLY 6XE B04 121VU HYDRAULIC/RAT/SPLY/EXTN/SOL1 2803GE P33
R **ON A/C 001-049, 051-061, 101-102, 201-202,
121VU HYDRAULIC/RAT/CTL 2801GE P32 R **ON A/C 103-105, 203-203,
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM HYDRAULIC POWER 液压5(111)