(2)
PREFERENTIAL ARRIVAL ROUTE/PAR - A specific arrival route from an appropriate enroute point to an airport or terminal area. It may be included in a Standard Terminal Arrival Route (STAR) or a Preferred IFR Route. The abbreviation “PAR” is used primarily within the ARTCC and should not be confused with the abbreviation for Precision Approach Radar.
(3)
PREFERENTIAL DEPARTURE AND ARRIVAL ROUTE/PDAR - A route between two terminals which are within or immediately adjacent to one ARTCC’s area. PDARS are not synonymous with Preferred IFR Routes but may be listed as such as they do accomplish essentially the same purpose. (See Preferred IFR Routes, NAS Stage A)
PREFERRED IFR ROUTES - Routes established between busier airports to increase system efficiency and capacity. They normally extend through one or more ARTCC areas and are designed to achieve balanced traffic flows among high density terminals. IFR clearances are issued on the basis of these routes except when severe weather avoidance procedures or other factors dictate otherwise. If a flight is planned to or from an area having such routes but the departure or arrival point is not listed, pilots may use that part of a Preferred IFR Route which is appropriate for the departure or arrival point that is listed. Preferred IFR Routes are correlated with SIDs and STARs and may be defined by airways, jet routes, direct routes between navigational aids, waypoints, navigational aid radials/DME, or any combinations thereof. (See Standard Instrument Departure, Standard Terminal Arrival, Preferential Routes, Center Area)
PREVAILING VISIBILITY - (See Visibility)
PROCEDURE TURN (JCS, NATO) - An aircraft maneuver in which a turn is made away from a designated track followed by a turn in the opposite direction, both turns being executed at a constant rate so as to permit the aircraft to intercept and proceed along the reciprocal of the designated track.
PROCEDURE TURN (ICAO) - A maneuver in which a turn is made away from a designated track followed by a turn in the opposite direction to permit the aircraft to intercept and proceed along the reciprocal of the designated track.
NOTE 1. - Procedure turns are designated "left" or "right" according to the direction of the initial turn.
NOTE 2. - Procedure turns may be designated as being made either in level flight or while descending, according to the circumstances of each individual approach procedure.
PROCEDURE TURN/PT (P/CG) - The maneuver prescribed when it is necessary to reverse direction to establish an aircraft on the intermediate approach segment or final approach course. The outbound course direction of turn, distance within which the turn must be completed, and minimum altitude are specified in the procedure. However, the point at which the turn may be commenced, and the type and rate of turn, are left to the discretion of the pilot.
PROCEDURE TURN INBOUND - That point of a procedure turn maneuver where course reversal has been completed and an aircraft is established inbound on the intermediate approach segment or final approach course. A report of "procedure turn inbound" is normally used by Air Traffic Control as a position report for separation purposes. (See Final Approach Course, Procedure Turn, Segments of an Instrument Approach Procedure)
PROFILE DESCENT - An uninterrupted descent (except where level flight is required for speed adjustment; e.g., 250 knots at 10,000 feet mean sea level) from cruising altitude/level to interception of a glide slope or to a minimum altitude specified for the initial or intermediate approach segment of a non-precision instrument approach. The profile descent normally terminates at the approach gate or where the glide slope or other appropriate minimum altitude is intercepted.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：FLIGHT INFORMATION PUBLICATION GENERAL PLANNING(64)
