-
the OFF legends of the FLT CTL/ELAC 1and FLT CTL/SEC 1 pushbutton switchesgo off.
On the FLT CTL panel 24VU:
-
the OFF legend of the FLT CTL/ELAC 2pushbutton switch goes off.
5. Close-up
________ Subtask 27-94-00-410-051
A. Close Access
(1)
If necessary, install the protective cover on the battery power center 105VU and tighten the two screws.
(2)
If necessary, close the access door 822 and remove the access platform.
Subtask 27-94-00-860-056
B. Put the aircraft back to its initial configuration.
(1)
On the FLT CTL panel 24VU:
-push the FLT CTL/SEC 3 pushbutton switch (on this pushbutton switch the OFF legend goes off).
(2)
Depressurize the aircraft hydraulic systems (Ref. TASK 29-10-00-864-003) (Ref. TASK 29-24-00-864-001) (Ref. TASK 29-23-00-864-001).
(3)
Do the EIS stop procedure (Ref. TASK 31-60-00-860-002).
(4)
De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002).
1EFF : ALL 1 27-94-00Page 518 1 1 May 01/04R 1 1 1CES 1
TASK 27-94-00-710-001
Operational Test of the Spoiler Elevator Computer 3 (SEC 3)
WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE CLEAR.
_______ MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
from the External Power 29-10-00-864-003 Depressurize the Blue Hydraulic System 29-23-00-863-001 Pressurize the Green Hydraulic System from the Yellow
Hydraulic System through the PTU with the Electric Pump 29-23-00-864-001 Depressurize the Green and Yellow Hydraulic Systems after Operation of the PTU 29-24-00-863-001 Pressurize the Yellow Hydraulic System with the
Electric Pump 29-24-00-864-001 Depressurize the Yellow Hydraulic System 31-60-00-860-001 EIS Start Procedure 31-60-00-860-002 EIS Stop Procedure
1EFF : ALL 1 27-94-00Page 519 1 1 May 01/04R 1 1 1CES 1
3. Job Set-up
__________ R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
Subtask 27-94-00-860-050
A. Aircraft Maintenance Configuration
(1)
Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
(2)
Make sure that the hydraulic systems are depressurized (Ref. TASK 29-10-00-864-003) (Ref. TASK 29-23-00-864-001) (Ref. TASK 29-24-00-864-001).
(3)
On the FLT CTL panels 23VU and 24VU, release the FLT CTL/ELAC 1, FLT CTL/ELAC 2, FLT CTL/SEC 1 and FLT CTL/SEC 2 (on these pushbutton switches, the OFF legends come on).
(4)
On the FLT CTL panel 24VU, make sure that the FLT CTL/SEC3 pushbutton switch is pushed (on this pusbutton switch, the OFF legend is off).
(5)
Do the EIS start procedure (Upper ECAM DU and lower ECAM DU only) (Ref. TASK 31-60-00-860-001).
(6)
On the center pedestal, on the ECAM control panel, push the F/CTL key (on the lower ECAM DU, the F/CTL page comes into view).
(7)
On the panel 114VU, make sure that the flap and slat control lever is not in position FULL.
**ON A/C 301-399,
Subtask 27-94-00-860-050-A
A. Aircraft Maintenance Configuration
(1)
Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
(2)
Make sure that the hydraulic systems are depressurized (Ref. TASK 29-10-00-864-003) (Ref. TASK 29-23-00-864-001) (Ref. TASK 29-24-00-864-001).
R R R (3) On the FLT CTL panels 23VU and 24VU, release the FLT CTL/ELAC 1, FLT CTL/ELAC 2, FLT CTL/SEC 1 and FLT CTL/SEC 2 (on these pushbutton switches, the OFF legends come on).
R R (4) On the FLT CTL panel 24VU, make sure that the FLT CTL/SEC3 pushbutton switch is pushed (on this pusbutton switch, the OFF legend is off).
R R (5) Do the EIS start procedure (Upper ECAM DU and lower ECAM DU only) (Ref. TASK 31-60-00-860-001).
R R (6) On the center pedestal, on the ECAM control panel, push the F/CTL key (on the lower ECAM DU, the F/CTL page comes into view).
R R (7) On the panel 114VU, make sure that the flap and slat control lever is not in position 3 or FULL.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM FLIGHT CONTROLS 飞行操纵9(97)
