A320飞机维护手册 AMM FLIGHT CONTROLS 飞行操纵9(161)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific access platform 1.6 m (5 ft. 3 in.)
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
 from the External Power 27-96-00-740-001 BITE Test of the EFCS (Ground Scanning) 29-10-00-863-001 Pressurize the Green Hydraulic System 29-10-00-863-002 Pressurize the Yellow Hydraulic System 29-10-00-863-003 Pressurize the Blue Hydraulic System with a Ground
 Power Supply 29-10-00-864-003 Depressurize the Blue Hydraulic System 29-23-00-864-001 Depressurize the Green and Yellow Hydraulic Systems
 after Operation of the PTU 29-24-00-864-001 Depressurize the Yellow Hydraulic System 31-60-00-860-001 EIS Start Procedure 31-60-00-860-002 EIS Stop Procedure

 3. Job Set-up
__________ Subtask 27-96-00-860-090
 A. Aircraft Maintenance Configuration
 (1)
 Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).

 (2)
 On the overhead panel 23VU:

 -Make sure that the FLT CTL/ELAC 1, FLT CTL/SEC 1 and FAC 1 pushbutton switches are pushed (on these pushbutton switches, the OFF and FAULT legends are off).

 (3)
 On the overhead panel 24VU:

 -Make sure that the FLT CTL/ELAC 2, FLT CTL/SEC 2, FLT CTL/SEC 3 and FAC 2 pushbutton switches are pushed (on these pushbutton switches, the OFF and FAULT legends are off).

 (4)
 On the overhead panel 20VU, on the ADIRS CDU:

 -set the 3 OFF/NAV/ATT selector switches to NAV.

 (5)
 Do the EIS start procedure (Ref. TASK 31-60-00-860-001).

 (6)
 On the center pedestal, on the ECAM control panel, push:

 -
the CLR key until all the warnings (if any) stop

 -
the F/CTL key (on the lower ECAM display unit, the F/CTL page comes into view).

 

 (7)
 Pressurize the Green, Yellow and Blue hydraulic systems (Ref. TASK 29-10-00-863-001) (Ref. TASK 29-10-00-863-002) (Ref. TASK 29-10-00-863-003).

 Subtask 27-96-00-010-067
 B. Get Access
 (1)
 Put the access platform in position at the access door 822.

 (2)
 Open the access door 822.

 (3)
 On the battery power center 105VU:

 -loosen the two screws and remove the protective cover.

 Subtask 27-96-00-865-089
 C. Make sure that this(these) circuit breaker(s) is(are) closed:
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/ELAC1/NORM/SPLY 15CE1 B11 49VU FLIGHT CONTROLS/THS/ACTR/MOT2 19CE2 B09 49VU FLIGHT CONTROLS/SEC1/NORM/SPLY 21CE1 B08 105VU FLIGHT CONTROLS/ELAC2/STBY SPLY 16CE2 A02 105VU FLT CTL/ELAC1/STBY SPLY 16CE1 A01 105VU FLT CTL/SEC1/STBY SPLY 22CE B01 121VU FLIGHT CONTROLS/SEC3/SPLY 21CE3 Q19 121VU FLIGHT CONTROLS/SEC2/SPLY 21CE2 Q18 121VU FLIGHT CONTROLS/THS ACTR/MOT3 19CE3 Q17 121VU FLIGHT CONTROLS/THS ACTR/MOT1 19CE1 Q16 121VU FLIGHT CONTROLS/ELAC2/NORM/SPLY 15CE2 R20
 4. Procedure_________
 Subtask 27-96-00-710-080
 A. Integrity Test
 NOTE : During the test, ignore the MASTER CAUT light and the single
____
 chime.

 -------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the overhead panel 23VU:
-release the FLT CTL/SEC 1 and FAC 1 pushbutton switches.
2. On the overhead panel 24VU:
-release the FLT CTL/ELAC 2, FLT CTL/SEC 2, FLT CTL/SEC 3 and FAC 2 pushbutton switches.
3. On the CAPT side:
-move the side stick to the right until it touches the stop.
On the overhead panel 23VU:
-
the OFF legends of the FLT CTL/SEC 1and FAC 1 pushbutton switches come on.

On the overhead panel 24VU:

-
the OFF legends of the FLT CTL/ELAC2, FLT CTL/SEC 2, FLT CTL/SEC 3 andFAC 2 pushbutton switches come on.

On the lower ECAM display unit:

-
the index of the right aileron movesup, the index of the left aileronmoves down.

 
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM FLIGHT CONTROLS 飞行操纵9(161)