B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 11-004 USA MIL-T-81533
1.1.1TRICHLOROETHANE (METHYL CHLOROFORM)
(Ref. 20-31-00) Material No. 19-003 USA AMS 3819
LINT-FREE COTTON CLOTH (Ref. 20-31-00)
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
29-10-00-864-001 Depressurize the Green Hydraulic System 29-10-00-864-003 Depressurize the Blue Hydraulic System ASRM 576000 (for corrective action) 57-60-00-991-001 Fig. 601
3. Job Set-up
__________
Subtask 57-60-00-941-050
A. Safety Precautions
(1)
Put the safety barriers in position.
(2)
Install the TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER (98D27803500001) on the flap/slat control lever.
(3)
Put warning notices in the cockpit to tell persons not to operate the flaps or slats.
(4)
Put warning notices in position to tell persons not to pressurize the hydraulic systems: - on the ground service panels
-in the cockpit, on the HYD overhead panel 40VU.
(5)
Put warning notices on the CAPT and F/O side sticks to tell persons not to operate the ailerons.
(6)
Put the access platform below the applicable aileron between hinge nos 3 and 4, zone 590 (690).
1EFF : ALL 1 57-60-00Page 602 1 1 Aug 01/99R 1 1 1CES 1
Subtask 57-60-00-860-050
B. Aircraft Maintenance Configuration
(1) Put the access platform below the applicable aileron between hinge nos 3 and 4, zone 590
(2) Make sure that these aircraft hydraulic systems are depressurized: - the Green hydraulic system (Ref. TASK 29-10-00-864-001) - the Blue hydraulic system (Ref. TASK 29-10-00-864-003).
Subtask 57-60-00-865-050
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------
PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
49VU FLIGHT CONTROLS/ELAC1/NORM/SPLY 49VU FLIGHT CONTROLS/SLT/CTL AND MONG/SYS1 105VU FLIGHT CONTROLS/ELAC2/STBY SPLY 105VU FLT CTL/ELAC1/STBY SPLY 121VU FLIGHT CONTROLS/SLT/CTL/SYS2 121VU FLIGHT CONTROLS/ELAC2/NORM/SPLY 15CE1 5CV 16CE2 16CE1 7CV 15CE2 B11B06A02A01R21R20
4. Procedure_________
(Ref. Fig. 601/TASK 57-60-00-991-001)
R R R R R R CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING_______ EDGE: - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS. - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS. - MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
Aileron - Upper and Lower Skins - Inspection
Figure 601/TASK 57-60-00-991-001
1EFF : ALL 1 57-60-00 Page 604
1 1 Feb 01/98
1 1
1CES 1
Subtask 57-60-00-110-050
A. Preparation for Inspection
WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL
_______ MATERIALS ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
(1) Use a MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-004) to clean the upper and lower skins of the aileron between hinge nos 3 and 4.
Subtask 57-60-00-210-050
B. Inspection
(1) Examine the upper and lower skins between hinge nos 3 and 4. Make sure that:
-
there is no damage
-
there is no delamination
-
there are no cracks
-the surface protection is in the correct condition.
NOTE : If necessary, refer to the ASRM (Ref. ASRM 576000) for the
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM WINGS 机翼5(83)
