-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
32-00-00-860-001 Flight Configuration Precautions with Electrical Power
**ON A/C 001-003, 051-052,
32-31-46-991-003 Fig. 403 R **ON A/C 004-049, 053-099, 101-149, 151-199, 201-299, 301-399, 401-499,
32-31-46-991-003-A Fig. 403A
**ON A/C ALL
3. Job Set-up
__________
**ON A/C 001-003, 051-052,
(Ref. Fig. 403/TASK 32-31-46-991-003) R **ON A/C 004-049, 053-099, 101-149, 151-199, 201-299, 301-399, 401-499,
(Ref. Fig. 403A/TASK 32-31-46-991-003-A)
**ON A/C ALL
Subtask 32-31-46-941-053
A. Safety Precautions
(1)
Put the safety barriers in position.
(2)
Make sure that the ground safety locks are installed on the landing gear (Ref. TASK 32-00-00-481-001).
1EFF : ALL 1 32-31-46Page 429 1 1 Aug 01/05 1 1 1CES 1
MLG Actuating Cylinder Eye-End Pin - Location and Detail Figure 403/TASK 32-31-46-991-003- 13 (SHEET 1)
R 1EFF : 001-003, 051-052, 1 32-31-46Page 430 1 1 May 01/05 1 1 1CES 1
MLG Actuating Cylinder Eye-End Pin - Location and Detail Figure 403/TASK 32-31-46-991-003- 23 (SHEET 2)
R 1EFF : 001-003, 051-052, 1 32-31-46Page 431 1 1 May 01/05 1 1 1CES 1
MLG Actuating Cylinder Eye-End Pin - Location and Detail Figure 403/TASK 32-31-46-991-003- 33 (SHEET 3)
R 1EFF : 001-003, 051-052, 1 32-31-46Page 432 1 1 May 01/05 1 1 1CES 1
INTENTIONALLY BLANK
R 1 1
32-31-46Page 433
1 1 Nov 01/04 1 1 1CES 1
MLG Actuating Cylinder Eye-End Pin - Location and Detail
Figure 403A/TASK 32-31-46-991-003-A12 (SHEET 1)
R 1EFF : 004-049, 053-099, 101-149, 151-199, 1 32-31-46Page 434 1201-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1
MLG Actuating Cylinder Eye-End Pin - Location and Detail
Figure 403A/TASK 32-31-46-991-003-A22 (SHEET 2)
R 1EFF : 004-049, 053-099, 101-149, 151-199, 1 32-31-46Page 435 1201-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1
(3)
On the panel 400VU:
-make sure that the landing-gear control-lever 6GA is in the DOWN position
-put a warning notice in position to tell persons not to operate the landing gear.
(4)
Put warning notices, to tell persons not to pressurize the hydraulic systems:
-in the cockpit, on the HYD overhead panel 40VU - on the hydraulic ground service-panels 197CB and 198CB - on the access door 195BB.
Subtask 32-31-46-869-054
R B. Flight Configuration Precautions
(1) If the electrical power is not necessary for other maintenance tasks, de-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002). Then it is not necessary to operate the LGCIU circuit breakers.
R (2) If the electrical power is necessary, do the flight configuration R precautions with electrical power (Ref. TASK 32-00-00-860-001) before R you open the circuit breakers.
Subtask 32-31-46-865-052
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU L/G/LGCIU/SYS1/NORM 1GA C09 121VU HYDRAULIC/LGCIU/SYS2 2GA Q35 121VU HYDRAULIC/LGCIU/SYS1/GRND SPLY 52GA Q34
Subtask 32-31-46-860-052
D. Aircraft Maintenance Configuration
(1)
Disconnect the isolation coupling of the PTU (Ref. TASK 29-23-00-860-001).
(2)
Make sure that the Yellow and Green Hydraulic systems are de-pressurized (Ref. TASK 29-00-00-864-001).
(3)
Make sure that the applicable hydraulic reservoirs have been depressurized (Ref. TASK 29-14-00-614-001).
R 1EFF : ALL 1 32-31-46Page 436 1 1 Nov 01/04 1 1 1CES 1 Subtask 32-31-46-010-053
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM LANDING GEAR 起落架5(26)
