R 32-33-00-720-001 Functional Check of Free-Fall Extension 32-33-00-820-002 Adjustment of the NLG Free-Fall Extension Mechanical System 32-33-11-991-002 Fig. 401 32-33-11-991-001 Fig. 402
3. Job Set-up
__________
(Ref. Fig. 401/TASK 32-33-11-991-002, 402/TASK 32-33-11-991-001)
Subtask 32-33-11-860-050
A. Aircraft Maintenance Configuration
(1)
In the cockpit, on the panel 400VU, make sure that the warning notice(s) is (are) in position to tell persons not to operate the landing gear control lever.
(2)
Make sure that the ground safety locks are on the landing gear (Ref. TASK 32-00-00-481-001).
(3)
Make sure that the NLG doors are open (Ref. TASK 32-22-00-010-001).
(4)
Make sure that the access platform is in position in zone 123.
(5)
Make sure that the access platform is in position below the lateral avionics-compatment door 822.
1EFF : ALL 1 32-33-11Page 407 1 1 Feb 01/04 1 1 1CES 1 1EFF : ALL 1 32-33-11Page 408 1 1 Feb 01/04 1 1 1CES 1 Subtask 32-33-11-420-050
(6) Make sure that the lateral avionics-compartment door 822 is open.
(7) Make sure that the PIN, RIGGING - RUDDER CONTROL (98A27901002000) (26) is in position on the lower bellcrank (27).
(8) Make sure that the RIGGING PIN (98A27801001000) (20) is in position on the cable quadrant (21).
Subtask 32-33-11-865-052
B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU AUTO FLT/FAC1/28VDC 5CC1 B04 49VU AUTO FLT/FAC1/26VAC 14CC1 B03 121VU AUTO FLT/RUDDER/TRIM/IND 15CC M20 121VU AUTO FLT/FAC2/28VDC 5CC2 M19 121VU AUTO FLT/FAC2/26VAC 14CC2 M18 122VU LIGHTING/INSTL LT/MAIN INST/PNL AND/PED 4LF Y04
4. Procedure_________
(Ref. Fig. 401/TASK 32-33-11-991-002, 402/TASK 32-33-11-991-001)
Subtask 32-33-11-110-050
A. Preparation for Installation
(1) Clean the connection components with CLEANING AGENTS (Material No. 11-002) and dry them with dry filtered compressed-air.
R R R (2) Apply a thin coat of COMMON GREASE (Material No. 04-004) or COMMON GREASE (Material No. 04-022) on the fasteners and on the splined shaft.
R R R R NOTE : Do not mix Material No. 04-004 with Material No. 04-022. You____ can use Material No. 04-022 as an alternative to Material No. 04-004. Clean and degrease the parts before you use Material No. 04-022.
