EICAS STATUS MESSAGES
None
PLACARD
As appropriate
B757 - 200 MINIMUM EQUIPMENT LIST
EICAS STATUS MESSAGES
None
PLACARD
As appropriate
B757 - 200 MINIMUM EQUIPMENT LIST
NUMBER INSTALLED
NUMBER REQUIRED FOR DISPATCH
1 1 REMARKS OR EXCEPTIONS
EICAS STATUS MESSAGES
None
PLACARD
As appropriate
EICAS STATUS MESSAGES
None
PLACARD
As appropriate
OPERATIONS NOTE
FASTEN SEAT BELT WHILE SEATED signs or placards are the placards for which MEL relief has been granted. Other signs and placards describing locations of flotation devices, etc. must be in place or replaced with interim placards. Signs and placards for inoperative passenger seats may be illegible or missing.
B757 - 200 MINIMUM EQUIPMENT LIST
EICAS STATUS MESSAGES
None
PLACARD
As appropriate
EICAS STATUS MESSAGES
NONE
PLACARD
As appropriate
OPERATIONS (O)
Ensure that the amount of operative Radio Beacon(s) is sufficient for intended operation(s).
B757 - 200 MINIMUM EQUIPMENT LIST
NUMBER INSTALLED
3
1 NUMBER REQUIRED FOR DISPATCH
REMARKS OR EXCEPTIONS
3 May be incomplete for a flight to a destination where repairs or replacements can be made but not to exceed a maximum of two flight days.
1 May be incomplete for a flight to destination where repairs or replacements can be made but not to exceed a maximum of two flight days.
1 0
EICAS STATUS MESSAGES
None
PLACARD
As appropriate
B757 - 200 MINIMUM EQUIPMENT LIST
NUMBER INSTALLED
-
- NUMBER REQUIRED FOR DISPATCH
REMARKS OR EXCEPTIONS
0 May be inoperative provided associated Escape
SLIDE Girt Bar Engagement Light(s) operates normally.
0 (O) For doors with flexible sweeper seals, may
be inoperative provided associated slide(s) is visually verified engaged before each departure.
0 (M) For doors with rigid sweeper seals, may be inoperative provided associated slide(s) is verified engaged before each departure.
-
EICAS STATUS MESSAGES
None
PLACARD
Near the escape SLIDE ENGAGED warning placard - SLIDE ENGAGED WARNING PLACARD INOP MAINTENANCE (M)
Verify girt bar engagement:
1. Remove escape slide bustle to gain access to girt bar floor fitting area.
2. Move the mode select handle between the disarmed and armed mode.
3. Verify that the forward and aft girt bar sliders travel a minimum of 1.00 inch between the disarmed and armed positions and that the sliders overlap the floor retainers.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 最低设备清单 Minimum Equipment List (MEL) 1(74)
