LIGHT-AFT EMER, OVERWING (62WL) connector A/C and GND,
PROX SW-HANDLE, R AFT EMER EXIT ESC SLIDE (6WN2) pin E and
EPSU (12WL) pin S,
PROX SW-HANDLE, R AFT EMER EXIT ESC SLIDE (6WN2) pin F and
GND,
PROX SW-HANDLE FLAP, R AFT EMER EXIT (21WV2) pin E and EPSU
(12WL) pin <K,
PROX SW-HANDLE FLAP, R AFT EMER EXIT (21WV2) pin F and GND
(Ref. ASM 33-51/02) and (Ref. AWM 33-51-04).
- install the old ESCAPE SLIDE OFFWING R (7505MM) (Ref. AMM TASK 25-62-42-400-001).
3 If the fault continues:
_
- replace the PROX SW-HANDLE, R AFT EMER EXIT ESC SLIDE (6WN2) (Ref. AMM TASK 52-73-11-000-004) and (Ref. AMM TASK 52-73-11-400-004).
4 If the fault continues:
_
- replace the PROX SW-HANDLE FLAP, R AFT EMER EXIT (21WV2) (Ref. AMM TASK 52-71-13-000-001) and (Ref. AMM TASK 52-71-13-400-001).
(c) If all lamps of the LIGHT-FWD EMER, OVERWING (60WL) and the LIGHT-AFT EMER, OVERWING (62WL) come on and no correct adapter cable between the escape slide and the aircraft electrical connector is available:
- remove the ESCAPE SLIDE OFFWING R (7505MM) (Ref. AMM TASK 25-62-42-000-001).
- connect a serviceable escape slide electrically only.
- do the operational test of the emergency lights not with CIDS (Ref. AMM TASK 33-51-00-710-006).
1 If the fault does no longer exist:
_
- install the serviceable escape slide (Ref. AMM TASK 25-62-42-400-001).
2 If the fault continues:
_
- do a check and repair the wiring between: escape slide connector 7532VC pin A and EPSU (12WL) pin T, escape slide connector 7532VC pin B and GND, LIGHT-FWD EMER, OVERWING (60WL) connector A/B and EPSU (12WL) pin T, LIGHT-FWD EMER, OVERWING (60WL) connector A/A and GND, LIGHT-FWD EMER, OVERWING (60WL) connector A/C and GND, LIGHT-AFT EMER, OVERWING (62WL) connector A/B and EPSU (12WL) pin F, LIGHT-AFT EMER, OVERWING (62WL) connector A/A and GND, LIGHT-AFT EMER, OVERWING (62WL) connector A/C and GND, PROX SW-HANDLE, R AFT EMER EXIT ESC SLIDE (6WN2) pin E and EPSU (12WL) pin S, PROX SW-HANDLE, R AFT EMER EXIT ESC SLIDE (6WN2) pin F and GND,
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 151-199, ∞∞33-51-00∞∞∞∞∞∞∞∞∞∞Page 276
May 01/05 CES
PROX SW-HANDLE FLAP, R AFT EMER EXIT (21WV2) pin E and EPSU
(12WL) pin <K,
PROX SW-HANDLE FLAP, R AFT EMER EXIT (21WV2) pin F and GND
(Ref. ASM 33-51/02) and (Ref. AWM 33-51-04).
- install the removed ESCAPE SLIDE OFFWING R (7505MM) again (Ref. AMM TASK 25-62-42-400-001).
3 If the fault continues:
_
- replace the PROX SW-HANDLE, R AFT EMER EXIT ESC SLIDE (6WN2) (Ref. AMM TASK 52-73-11-000-004) and (Ref. AMM TASK 52-73-11-400-004).
4 If the fault continues:
_
- replace the PROX SW-HANDLE FLAP, R AFT EMER EXIT (21WV2) (Ref. AMM TASK 52-71-13-000-001) and (Ref. AMM TASK 52-71-13-400-001).
R **ON A/C 001-003, 051-052,
E. If the operational test gives the maintenance message
EPSU EXT LOAD AFT L:
- do the operational test of the emergency lights not with CIDS (Ref. AMM TASK 33-51-00-710-006).
(1) If the green LED 'OK EXTERNAL LOADS' comes on:
- replace the POWER SUPPLY UNIT-EMERGENCY (13WL) (Ref. AMM TASK 33-51-38-000-001) and (Ref. AMM TASK 33-51-38-400-001).
(2) If the red LED 'FAULT EXTERNAL LOADS' comes on and a correct adapter cable between the escape slide and the aircraft electrical connector is available:
NOTE : A fault in one of the two aft escape slides can cause the LED
____
to come on.
(a) Do the subsequent procedures:
- remove the ESCAPE SLIDE AFT L (7502MM) as necessary to get access to the electrical connector (Ref. AMM TASK 25-62-44-000-002).
- connect a serviceable escape slide with the adapter cable to the aircraft.
(b) If the fault does no longer exist:
- remove the old ESCAPE SLIDE AFT L (7502MM) fully (Ref. AMM TASK 25-62-44-000-002).
- install the serviceable escape slide (Ref. AMM TASK 25-62-44-400-001).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-003, 051-052, 151-199, ∞∞33-51-00∞∞∞∞∞∞∞∞∞∞Page 277
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320 Trouble Shooting Manual 排故手册 LIGHTS 灯光(110)
