(10) Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
WARNING : MAKE SURE THAT ALL THE CIRCUITS IN MAINTENANCE ARE ISOLATED
_______ BEFORE YOU SUPPLY ELECTRICAL POWER TO THE AIRCRAFT.
4. Procedure
_________ Subtask 28-21-00-710-060
A. Procedure A
(1)
Make sure that the engine LP valves are closed. NOTE : An amber cross-line on the ECAM display unit (DU) shows that
____
the LP valves are closed.
(2)
Do this check for the air-release valve (ARV) on the feed line of the LH engine:
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the panel 40VU:
-make sure that the X FEED - the ECAM DU shows the crossfeed valve pushbutton switch is released is closed (cross-line). (out).
2. On the overhead panel 25VU:
-push the APU MASTER SW 14KD - the APU fuel shutoff valve moves to
pushbutton switch. the open position and the APU fuel pump starts.
1EFF : ALL 1 28-21-00Page 587 1 1 Aug 01/05R 1 1 1CES 1
Installation of the Fuel Feed Test Kit Figure 504/TASK 28-21-00-991-005
1EFF : 1 1R 1CES ALL 1 11 1 28-21-00 Page 588 Aug 01/05
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
3. Monitor the fuel flow for 5 - the fuel flow must be normal and
minutes. there must be no air bubbles in the fuel.
NOTE : There can be air bubbles in the fuel during the initial fuel flow,
____ this must quickly stop.
4.
If the air bubbles do not stop, or no fuel flows, replace the LH ARV (Ref. TASK 28-21-41-000-001) (Ref. TASK 28-21-41-400-001). If you replace the LH ARV do the check again.
5.
On the overhead panel 25VU:
-push the APU MASTER SW 14KD pushbutton switch again.
Subtask 28-21-00-710-061
-the APU fuel shutoff valve moves tothe closed position and the APU fuel pump stops.
B. Do this check for the air-release valve (ARV) on the feed line of the RH engine:
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the panel 40VU:
- push (in) the X FEED pushbutton - the ECAM DU shows the crossfeed valve
switch. is open (in-line)
- the ON and OPEN legends come on.
2. On the overhead panel 25VU:
- push (in) the APU MASTER SW - the APU LP fuel shutoff valve moves
14KD pushbutton switch. to the open position and the APU fuel
pump starts.
3. Monitor the fuel flow for 5 - the fuel flow must be normal and
minutes. there must be no air bubbles in the
fuel.
NOTE : There can be air bubbles in the fuel during the initial fuel flow but
____ these must quickly stop.
1EFF : ALL 1 28-21-00Page 589 1 1 Aug 01/05R 1 1 1CES 1
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
4.
If the air bubbles do not stop, or no fuel flows, replace the RH ARV (Ref. TASK 28-21-41-000-001) (Ref. TASK 28-21-41-400-001). If you replace the RH ARV do the check again.
5.
On the panel 40VU:
-release (out) the X FEED - the ON and OPEN legends go off
pushbutton switch.
-the ECAM DU shows the crossfeed valve is closed (cross-line).
6. On the overhead panel 25VU:
-push the APU MASTER SW 14KD - the APU LP fuel shutoff valves moves
pushbutton switch again. to the closed position and the APU fuel pump stops.
Subtask 28-21-00-860-067
C. Aircraft Configuration
(1)
De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002).
(2)
Put a container in position below the APU fuel feed pipe at the connection to the TEST EQUIPMENT-APU FUEL FEED.
(3)
Remove the TEST EQUIPMENT-APU FUEL FEED.
(4)
Remove the blanking cap from the inlet connection of the tee assembly (1).
(5)
Install the APU fuel feed pipe (4) to the inlet connection of the tee assembly (1).
(6)
Connect the pipe coupling nut (6) to the inlet connection of the tee assembly (1).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM FUEL 燃油3(6)
