B. Aircraft Maintenance Configuration
(1)
Make sure that the applicable fuel tank is defueled (Ref. TASK 28-25-00-650-001).
(2)
Make sure that the remaining fuel has been drained from the applicable fuel tank (Ref. TASK 28-25-00-650-003).
(3)
Make sure that the access platform is below the applicable access panel 540AB(640AB).
(4)
Make sure that the applicable wing access panel is removed (Ref. TASK 28-10-00-910-002), (Ref. TASK 57-27-11-000-001):
-
FOR 33QM, 34QM
540AB
-
FOR 35QM, 36QM
640AB
(5)
Make sure that the applicable RIB2 surge door is open:
-
FOR 33QM, 34QM
open 540BZ
-
FOR 35QM, 36QM
open 640BZ
(6)
Make sure that the HOOK-COVER (RIB2-SURGE DOORS) (98D57004014000) is on the applicable RIB2 surge door.
Subtask 28-21-43-865-055
C. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU FUEL/L WING TK/PUMP2 SPLY 7QA N26 121VU FUEL/L WING TK/PUMP1 SPLY 1QA N23 121VU FUEL/R WING TK/PUMP2 SPLY 8QA Q26 121VU FUEL/R WING TK/PUMP1 SPLY 2QA Q23 123VU L WING TK/PUMP 1/STBY SPLY 11QA AD12 123VU R WING TK/PUMP 1/STBY SPLY 12QA AE12
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-21-43Page 408 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
4. Procedure
_________
(Ref. Fig. 401/TASK 28-21-43-991-001) Subtask 28-21-43-420-052
A. Preparation for Installation
WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL
_______ MATERIALS ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
(1)
Clean the component interfaces and the adjacent areas with a MISCELLANEOUS (Material No. 19-003) made moist with CLEANING AGENTS (Material No. 11-004).
(2)
Make sure that the parts retained from the removed component are clean and in the correct condition.
(3)
Do an inspection of the component interface and/or the adjacent area.
(4)
Make sure that the check-valve (2) opens and closes correctly.
(5)
Lubricate the new O-ring (1) with FUELS (Material No. 01-001) or COMMON GREASE (Material No. 04-012).
Subtask 28-21-43-420-050
B. Installation of the Fuel-Pump Check-Valve 33QM(36QM), 34QM(35QM)
(1)
Install the O-ring (1) on the check-valve (2).
(2)
Remove the blanking plugs from the disconnected line ends.
(3)
Install the check-valve (2).
(4)
Connect the pipe (3) at the check-valve (2).
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-21-43Page 409 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1 Subtask 28-21-43-410-050
C. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the HOOK-COVER (RIB2-SURGE DOORS) from the applicable RIB2 surge door.
(3)
Close the rib 2 rear access door:
-
FOR 33QM, 34QM
close 540BZ.
-
FOR 35QM, 36QM
close 640BZ.
(4)
Install the wing access panel (Ref. TASK 28-10-00-910-002), (Ref. TASK 57-27-11-400-001):
-
FOR 33QM, 34QM
install 540AB.
-
FOR 35QM, 36QM
install 640AB.
Subtask 28-21-43-865-051
D. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 1QA, 2QA, 7QA, 8QA, 11QA, 12QA.
Subtask 28-21-43-710-051
E. Operational Test
(1) Do the operational test of the check valves 33QM(36QM) and 34QM(35QM) (Ref. TASK 28-21-00-710-002).
5. Close-up
________
Subtask 28-21-43-860-051
A. Aircraft Configuration
(1) Refuel, defuel or transfer fuel as necessary (Ref. TASK 12-11-28-650-003), (Ref. TASK 28-25-00-650-001) or (Ref. TASK 28-25-00-869-001).
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-21-43Page 410 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1 Subtask 28-21-43-942-051
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM FUEL 燃油3(32)
