C.
Access
(1)
Location Zone
412 Engine 1 - Intermediate Case 6 o'clock
422 Engine 2 - Intermediate Case 6 o'clock
432 Engine 3 - Intermediate Case 6 o'clock
442 Engine 4 - Intermediate Case 6 o'clock
(2)
Access Panel 415 and 416 Thrust Reverser Halves - Engine 1 425 and 426 Thrust Reverser Halves - Engine 2 435 and 436 Thrust Reverser Halves - Engine 3 445 and 446 Thrust Reverser Halves - Engine 4
D.
Prepare for the removal of the angle gearbox.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
72-62-01
ALL ú ú N02 Page 401 ú Jun 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / PW4000 SERIES /747-400 / ENGINES/MAINTENANCE MANUAL ////////////////////////
S 044-065-N00
WARNING: DO THE THRUST REVERSER DEACTIVATION PROCEDURE TO PREVENT THE
_______ OPERATION OF THE THRUST REVERSER. THE ACCIDENTAL OPERATION OF THE THRUST REVERSER CAN CAUSE INJURIES TO PERSONS OR DAMAGE TO EQUIPMENT.
(1)
Do this task: Thrust Reverser Deactivation for Ground Maintenance (AMM 78-31-00/201).
S 014-067-N00
(2)
Open the fan cowl panels (AMM 71-11-04/201).
S 014-068-N00
(3)
Open the core cowl panels (AMM 71-11-06/201).
S 014-066-N00
WARNING: OBEY THE INSTRUCTIONS IN AMM 78-31-00 WHEN YOU OPEN THE THRUST
_______ REVERSERS. IF YOU DO NOT OBEY THE INSTRUCTIONS, INJURIES TO PERSONS OR DAMAGE TO EQUIPMENT CAN OCCUR.
(4)
Open the thrust reversers (AMM 78-31-00/201).
S 494-004-N00
(5)
Put the container under the angle gearbox (11) and the drive shaft housing (5) to collect the oil (Fig. 401).
E.
Remove the angle gearbox.
S 014-098-N00
(1)
Remove the tubes, wire bundles and fire detecters as follows (Fig. 401):
(a)
Remove screw (3) and washer (2) which attaches the clamp for the actuator drain tube of the 2.5 bleed valve to the bracket (7).
NOTE: This bracket (7) is on the angle gearbox (11) at the
____ 8:00 o'clock position.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
72-62-01
ALL ú ú N02 Page 402 ú Jun 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
SEE A
BEARINGS AND 2 NO. 1, 1.5, TUBE FOR THE OIL SCAVENGE SEE G SEE G
2
SEE H 1 SEE F
SEE B
A A
SEE C
SEE E
HYDRAULIC MANIFOLD BOTTOM
COOLER INLET OF THE OIL RETURN MANIFOLD
1 2 3 4 5 ENGINES POST-PW-SB 72-709 ENGINES PRE-PW-SB 72-709 ENGINES POST-PW-SB 75-45 ENGINES POST-PW-SB 79-54 ENGINES PRE-PW-SB 79-54 A FWD BOTTOM VIEW L-A1851 (0891)
Angle Gearbox Installation
Figure 401 (Sheet 1)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
72-62-01
ALL ú ú N01 Page 403 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
D21465
////////////////////////A / PW4000 SERIES /747-400 / ENGINES /MAINTENANCE MANUAL ////////////////////////
INTERMEDIATE CASE
29. TOWER SHAFT
11. GEARBOX ANGLE 26. PACKING 5. HOUSING DRIVE SHAFT 20. SHAFT DRIVE MAIN GEARBOX SPUR GEAR SHAFT
18. PACKING
BEVEL GEAR 33. SNAP RING 31. PLUG FAN EXIT CASE FLANGE 21. SNAP RING A-A 23. PACKING DRIVE SHAFT HOUSING REAR
L-A0532
Angle Gearbox Installation
Figure 401 (Sheet 2)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú 中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址：747-400 AMM 飞机维护手册 发动机 ENGINE 2(168)
