• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-03-27 12:50来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS


 -COMPONENTS THAT MOVE.
 CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:
_______
 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.


 -MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
 1. Reason for the Job
__________________
 Refer to the MPD TASK: 575350-02
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s) No specific clamp No specific protective pads No specific safety barriers No specific warning notices No specific access platforms 3.5 m (11 ft. 6 in.)
 1EFF : ALL 1 57-53-00Page 686 1 1 May 01/05R 1 1 1CES 1


 B. Consumable Materials
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 11-026 GB DEF-STAN 68-148/1
 SOLVENT GENERAL PURPOSE (Ref. 20-31-00) Material No. 19-003 USA AMS 3819
 LINT-FREE COTTON CLOTH (Ref. 20-31-00)
 C. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-50-00-866-008 Extension of the Flaps on the Ground 27-50-00-866-009 Retraction of the Flaps on the Ground 27-54-62-000-001 Removal of the Outboard Flap 27-54-62-400-001 Installation of the Outboard Flap 57-55-11-010-002 To Lower the Flap Track No. 3 & No. 4 Movable
 Fairings for Access 57-55-11-410-002 To Lift the Flap Track No. 3 & No. 4 Movable Fairings
 after Access NTM 57-53-50 PART 4 ASRM 575300 (for corrective action) 57-53-00-991-014 Fig. 613
 3. Job Set-up
__________
 Subtask 57-53-00-941-063
 A. Safety Precautions
 (1)
 Put warning notices in the cockpit to tell persons not to operate the flaps or slats.

 (2)
 Put the safety barriers in position.


 1EFF : ALL 1 57-53-00Page 687 1 1 May 01/05R 1 1 1CES 1


 Subtask 57-53-00-860-094
 B. Aircraft Maintenance Configuration
 (1)
 Extend the flaps fully (Ref. TASK 27-50-00-866-008).

 (2)
 Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is installed on the flap/slat control lever.


 Subtask 57-53-00-865-075
 C. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/SEC1/NORM/SPLY 21CE1 B08 49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
 Subtask 57-53-00-010-062
 D. Get Access
 (1)
 Put the access platforms below the applicable wing trailing edge at flap tracks 3 and 4, zones 532(632) and 533(633).

 (2)
 Lower the flap track 3 and 4 movable fairings (Ref. TASK 57-55-11-010-002).


 4. Procedure
_________ (Ref. Fig. 613/TASK 57-53-00-991-014) CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING
_______
 EDGE:

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.


 -MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
 1EFF : ALL 1 57-53-00Page 688 1 1 May 01/05R 1 1 1CES 1


 Flap Tracks 3 and 4 - Carriage Forgings Figure 613/TASK 57-53-00-991-014
 1EFF : 1 1R 1CES  ALL  1 11 1 57-53-00 Page 689 May 01/05

 

 Subtask 57-53-00-110-061
 A. Preparation for Inspection
 (1)
 Disconnect the outboard flap from the flap track 3 and 4 carriages (Ref. TASK 27-54-62-000-001). Do not remove the end stop from the flap track.

 (2)
 Move the applicable carriage along the flap track, until you can get clear access to the carriage forging.
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM WINGS 机翼4(88)