R 1EFF : 301-399, 1 57-52-00Page 695 1 1 May 01/04 1 1 1CES 1
R B. Consumable Materials
R -------------------------------------------------------------------------------
R REFERENCE DESIGNATION
R -------------------------------------------------------------------------------
R Material No. 08-061A D DAN 220
R ALUMINIUM FOIL ADHESIVE TAPE (Ref. 20-31-00)
R Material No. 11-026 GB DEF-STAN 68-148/1
R SOLVENT GENERAL PURPOSE (Ref. 20-31-00)
R Material No. 19-003 USA AMS 3819
R LINT-FREE COTTON CLOTH (Ref. 20-31-00)
R C. Referenced Information
R -------------------------------------------------------------------------------
R REFERENCE DESIGNATION
R -------------------------------------------------------------------------------
R 27-50-00-866-008 Extension of the Flaps on the Ground
R 27-50-00-866-009 Retraction of the Flaps on the Ground
R NTM 57-52-23 PART 9
R ASRM 575200 (for corrective action)
R 57-52-00-991-016 Fig. 616
R 3. Job Set-up__________
R Subtask 57-52-00-941-069
R A. Safety Precautions
R (1) Put a warning notice on the flap/slat control lever (panel 114VU) to
R tell persons not to operate the flaps.
R (2) Put the safety barriers in position.
R Subtask 57-52-00-860-052
R B. Aicraft Maintenance Configuration
R WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE_______
R CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS
R AND/OR DAMAGE.
R (1) Fully extend the flaps (Ref. TASK 27-50-00-866-008).
R 1EFF : 301-399, 1 57-52-00Page 696 1 1 May 01/04 1 1 1CES 1
R (2) Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is
R installed on the flap/slat control lever on the panel 114VU.
R Subtask 57-52-00-865-086
R C. Open, safety and tag this(these) circuit breaker(s):
R -------------------------------------------------------------------------------
R PANEL DESIGNATION IDENT. LOCATION
R -------------------------------------------------------------------------------
R 49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07
R 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
R Subtask 57-52-00-010-067
R D. Get Access
R (1) Put the access platform in position below the zone 581(681).
R (2) Remove the access panel 581AT (681AT) from the upper surface of the
R flap.
R (3) Remove and discard the covers to the inspection holes in the lower
R surface of the flap.
R (4) Make sure that the applicable inspection holes are clear of unwanted
R material.
R 4. Procedure_________
R (Ref. Fig. 616/TASK 57-52-00-991-016)
R CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING_______
R EDGE:
R - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
R - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
R - MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY.
R INCORRECT INSTALLATION CAN CAUSE DAMAGE.
R Subtask 57-52-00-110-063
R A. Cleaning
R (1) Use CLEANING AGENTS (Material No. 11-026) and a clean MISCELLANEOUS
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM WINGS 机翼4(36)
