-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:
_______
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
1. Reason for the Job
__________________
Refer to the MPD TASK: 575250-02
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s) No specific clamp No specific protective pad No specific safety barriers No specific warning notice No specific access platform 2.5 m (8 ft. 2 in.)
1EFF : ALL 1 57-52-00Page 630 1 1 May 01/05R 1 1 1CES 1
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 11-026 GB DEF-STAN 68-148/1 SOLVENT GENERAL PURPOSE (Ref. 20-31-00) Material No. 19-003 USA AMS 3819 LINT-FREE COTTON CLOTH (Ref. 20-31-00)
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-50-00-866-008 Extension of the Flaps on the Ground 27-50-00-866-009 Retraction of the Flaps on the Ground 27-54-61-000-001 Removal of the Inboard Flap 27-54-61-400-001 Installation of the Inboard Flap 57-55-11-010-001 To Lower the Flap Track No. 2 Movable Fairing for
Access 57-55-11-410-001 To Lift the Flap Track No. 2 Movable Fairing after
Access NTM 57-52-50 PART 4 ASRM 575100 (for corrective action) 57-52-00-991-006 Fig. 606
3. Job Set-up
__________
Subtask 57-52-00-941-059
A. Safety Precautions
(1)
Put warning notice in the cockpit to tell persons not to operate the flaps or slats.
(2)
Put the safety barriers in position.
1EFF : ALL 1 57-52-00Page 631 1 1 May 01/04R 1 1 1CES 1
Subtask 57-52-00-860-095
B. Aircraft Maintenance Configuration
(1)
Extend the flaps fully (Ref. TASK 27-50-00-866-008).
(2)
Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is installed on the flap/slat control lever.
(3)
Put the access platform below the applicable wing trailing edge at flap track 2, zone 531(631).
Subtask 57-52-00-865-066
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
Subtask 57-52-00-010-057
D. Get Access R (1) Lower the flap track 2 movable fairing (Ref. TASK 57-55-11-010-001).
(2)
Disconnect the inboard flap from the flap track 2 carriage (Ref. TASK 27-54-61-000-001). Do not remove the end stop from the flap track.
(3)
Move the carriage along the flap track, until you can get clear access to the carriage forging.
R (4) Use a clamp to hold the carriage in position on the flap track. Use a protective pad to prevent damage to the flap track surfaces.
4. Procedure
_________ (Ref. Fig. 606/TASK 57-52-00-991-006) CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING
_______
EDGE:
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
Flap Track 2 - Carriage Forging Figure 606/TASK 57-52-00-991-006
1EFF : 1 1R 1CES ALL 1 11 1 57-52-00 Page 633 May 01/04
Subtask 57-52-00-110-058
A. Preparation for Inspection
(1) Use a MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-026) to clean the carriage forging.
(2) If applicable, clean the rear face of the carriage forging.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM WINGS 机翼4(20)
