(3)
On the top skin, remove and discard the cover from the inspection hole at track 2.
4. Procedure
_________ (Ref. Fig. 613/TASK 57-52-00-991-013) CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING
_______
EDGE:
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
Subtask 57-52-00-280-055
A. Inspection
(1) Do a special detailed inspection of the internal bracket of the inboard flap at track 2 LH/RH (Ref. NTM 57-52-06 PART 9).
NOTE : If necessary, refer to the ASRM (Ref. ASRM 575200) for the
____ correct repair procedure. If the defect is not included in this repair, you must request a procedure from Airbus Industrie.
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 57-52-00Page 678 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
5. Close-up
________ Subtask 57-52-00-410-064
A. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
On the top skin:
(a)
Use BONDING AND ADHESIVE COMPOUNDS (Material No. 08-061A) cut to the correct dimension, to make a new cover for the inspection hole.
(b)
Install the new cover on the inspection hole.
(3)
Install the flap track 2 fairing 531CB (631CB) and the access panel 531AT (631AT) (Ref. TASK 57-55-11-400-001).
Subtask 57-52-00-865-081
B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 6CV, 8CV.
Subtask 57-52-00-860-104
C. Aircraft Maintenance Configuration
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the LOCKING TOOL - FLAP/SLAT CONTROL LEVER from the flap/slat control lever
(3) Retract the flaps (Ref. TASK 27-50-00-866-009). Subtask 57-52-00-942-065
D. Removal of Equipment
(1)
Remove the access platform(s).
(2)
Remove the warning notice(s).
(3)
Remove the safety barriers.
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 57-52-00Page 679 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
Flap Track 2 - Internal Bracket - Location Figure 613/TASK 57-52-00-991-013- 12 (SHEET 1)
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 57-52-00Page 680 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
Flap Track 2 - Internal Bracket - Location Figure 613/TASK 57-52-00-991-013- 22 (SHEET 2)
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 57-52-00Page 681 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
(4) Remove the ground support and maintenance equipment, the special and
standard tools and all other items.
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 57-52-00Page 682 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
TASK 57-52-00-200-009
Detailed Visual Inspection of Inboard Flap, Flap to Carriage Attachment Bracket at Track 2, including surrounding Skin LH/RH
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:
_______
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
1. Reason for the Job
__________________
Refer to the MPD TASK: 575207-01
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific safety barriers No specific warning notices No specific access platform 2.5 m (8 ft. 2 in.)
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 57-52-00Page 683 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1 B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM WINGS 机翼4(32)
