R Inboard Flap - Tab Drive Assembly and Articulation at Rib 3 - Inspection Area R Figure 623/TASK 57-52-00-991-023
 1EFF : 301-399, 1 57-52-00Page A635 1 1 May 01/04 1 1 1CES 1
R  (2) Do an inspection of the forward and middle levers, the front and aft  
R  flap brackets, the tab joining, tab leader ship and the bracket. Make  
R  sure that:  
R  - there is no damage  
R  - there is no corrosion  
R  - there are no cracks or scores  
R  - the surface protection is in the correct condition.  
R  NOTE : If necessary, refer to the ASRM (Ref. ASRM 575200) for the____  
R  correct repair procedure.  
R  5. Close-up________  
R  Subtask 57-52-00-410-076  
R  A. Close Access  
R  (1) Remove the spark-proof lamp from the inspection area.  
R  (2) Make sure that the work area is clean and clear of tool(s) and other  
R  items.  
R  (3) Install the applicable inboard flap tab hinge-fairing (Ref. TASK 57- 
R  55-11-400-005):  
R  - for the left wing, install 535AB, 535BB  
R  - for the right wing, install 635AB, 635BB.  
R  Subtask 57-52-00-865-102  
R  B. Remove the safety clip(s) and the tag(s) and close this(these) circuit  
R  breaker(s):  
R  6CV, 8CV.  
R  Subtask 57-52-00-860-068  
R  C. Aircraft Maintenance Configuration  
R  (1) Fully retract the flaps (Ref. TASK 27-50-00-866-009).  
R  Subtask 57-52-00-942-075  
R  D. Removal of Equipment  
R  (1) Remove the access platform(s).  
R  (2) Remove the safety barriers.
R (3) Remove the warning notice(s). 
R (4) Remove the ground support and maintenance equipment, the special and R standard tools and all other items.
R  TASK 57-52-00-210-007  
R  Detailed Visual Inspection of Inboard Double Slotted Flap, Tab Articulation at  
R  RIB6, LH/RH  
R  WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU_______  
R  START A TASK ON OR NEAR:  
R  - THE FLIGHT CONTROLS  
R  - THE FLIGHT CONTROL SURFACES  
R  - THE LANDING GEAR AND THE RELATED DOORS  
R  - COMPONENTS THAT MOVE.  
R  WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING_______  
R  GEAR.  
R  CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:_______  
R  - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.  
R  - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.  
R  - MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY.  
R  INCORRECT INSTALLATION CAN CAUSE DAMAGE.  
R  1. Reason for the Job__________________  
R  Refer to the MPD TASK: 575235-01  
R  2. Job Set-up Information______________________  
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM WINGS 机翼4(47)