R 1EFF : 301-399, 1 57-52-00Page 691 1 1 May 01/04 1 1 1CES 1R Inboard Flap - Trunnion and Attachment Bracket - Inspection Area R Figure 615/TASK 57-52-00-991-015
R 1EFF : 301-399, 1 57-52-00Page 692 1 1 May 01/04 1 1 1CES 1
R Subtask 57-52-00-210-059
R  B. Detailed Visual Inspection of Inboard Double Slotted Flap, Trunnion  
R  Attachment Bracket, LH/RH.  
R  (1) Do an inspection of the external surface of the trunnion attachment  
R  bracket and the inboard trunnion, where it can be seen. Make sure  
R  that:  
R  - there is no damage  
R  - there is no corrosion  
R  - there are no cracks or scores  
R  - the surface protection is in the correct condition.  
R  NOTE : If necessary, refer to the ASRM (Ref. ASRM 575200) for the____  
R  correct repair procedure.  
R  5. Close-up________  
R  Subtask 57-52-00-410-066  
R  A. Close Access  
R  (1) Remove the spark-proof lamp from the inspection area.  
R  (2) Make sure that the work area is clean and clear of tool(s) and other  
R  items.  
R  (3) Install the inboard flap seals (Ref. TASK 27-54-61-400-007).  
R  (4) Install the applicable access panel:  
R  - for the left wing, install 581AT  
R  - for the right wing, install 681AT.  
R  Subtask 57-52-00-865-085  
R  B. Remove the safety clip(s) and the tag(s) and close this(these) circuit  
R  breaker(s):  
R  6CV, 8CV.  
R  Subtask 57-52-00-860-051  
R  C. Aircraft Maintenance Configuration  
R  (1) Fully retract the flaps (Ref. TASK 27-50-00-866-009). 
R 1EFF : 301-399, 1 57-52-00Page 693 1 1 May 01/04 1 1 1CES 1
R  Subtask 57-52-00-942-067  
R  D. Removal of the Equipment  
R  (1) Remove the access platform(s).  
R  (2) Remove the safety barriers.  
R  (3) Remove the warning notice(s).  
R  (4) Remove the ground support and maintenance equipment, the special and  
R  standard tools and all other items. 
R 1EFF : 301-399, 1 57-52-00Page 694 1 1 May 01/04 1 1 1CES 1
R  TASK 57-52-00-220-009  
R  Special Detailed Inspection of Inboard Double Slotted Flap, Trunnion Attachment  
R  Bracket, including Inboard Trunnion, LH/RH  
R  WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU_______  
R  START A TASK ON OR NEAR:  
R  - THE FLIGHT CONTROLS  
R  - THE FLIGHT CONTROL SURFACES  
R  - THE LANDING GEAR AND THE RELATED DOORS  
R  - COMPONENTS THAT MOVE.  
R  WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING_______  
R  GEAR.  
R  CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:_______  
R  - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.  
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM WINGS 机翼4(35)