A320飞机维护手册 AMM LANDING GEAR 起落架4(72)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

No specific  circuit breaker(s) safety clip(s)
R  No specific colored adhesive tape No specific safety barriers No specific warning notice No specific warning notice(s)
R  36122 1 ADAPTOR-CHARGING,PITOT PROBE
R  87202126V15 1 GENERATOR - GROUND PRESSURE 98D24408392000 1 98D27803500001 1 TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER 98D29207542000 1 SAFETY DEVICE - RAT 98D29208246001 1 SAFETY DEVICE - RAT
R  98D34003500000 1 ADAPTER COVER-STATIC PORT 98F32304000000 1 FALSE TARGET
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
 from the APU 25-11-41-000-001 Removal of the Third Occupant Seat 25-11-41-400-001 Installation of the Third Occupant Seat 27-50-00-866-009 Retraction of the Flaps on the Ground 27-80-00-866-005 Retracting the Slats on the Ground 29-22-00-860-001 Installation of the Safety Device of the Ram Air
 Turbine 29-22-00-860-002 Removal of the Safety Device of the Ram Air Turbine 29-22-00-860-007 Installation of the Safety Device of the Ram Air
 Turbine 29-22-00-860-008 Removal of the Safety Device of the Ram Air Turbine 29-24-00-863-001 Pressurize the Yellow Hydraulic System with the
 Electric Pump
 29-24-00-864-001 Depressurize the Yellow Hydraulic System

 1EFF : ALL 1 32-31-00Page 552 1 1 May 01/05 1 1 1CES 1 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------

32-00-00-481-001 Installation of the Safety Devices on the Landing Gears 32-00-00-860-001 Flight Configuration Precautions with Electrical Power 32-00-00-860-002 Ground Configuration after Flight Configuration with
 Electrical Power TSM 32 PB 101 (for corrective action) 32-31-00-991-025 Fig. 505 32-31-00-991-019 Fig. 506
 3. Job Set-up
__________
 **ON A/C 001-049, 051-061, 101-105, 201-203,
 Subtask 32-31-00-941-087
 A. Safety Precautions
 (1)
 Put the safety barriers in position.

 (2)
 Make sure that the ground safety locks are installed on the landing gear (Ref. TASK 32-00-00-481-001).

 (3)
 Install the SAFETY DEVICE - RAT (98D29207542000) (Ref. TASK 29-22-00-860-001).

 (4)
 Make sure that the slats/flaps are fully retracted (Ref. TASK 27-80-00-866-005) (Ref. TASK 27-50-00-866-009).

 (5)
 Install the TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER (98D27803500001) on the slat/flap control lever.

 (6)
 Make sure that the external power connector is not connected to the aircraft receptacle.

 (7)
 Put warning notice(s) on the access door 121AL to tell persons not to use the external power receptacle.

 1EFF : ALL 1 32-31-00Page 553 1 1 Aug 01/05R 1 1 1CES 1

 (8)
 On the panel 400VU:

 -make sure that the landing-gear control-lever 6GA is in the DOWN position
 -put a warning notice in position to tell persons not to operate the landing gear.

 (9)
 Put a warning notice on the flap/slat control lever to tell persons not to operate the flap/slat system.

R **ON A/C 062-099, 106-149, 151-199, 204-299, 301-399, 401-499,
 Subtask 32-31-00-941-087-A
 A. Safety Precautions
 (1)
 Put the safety barriers in position.

 (2)
 Make sure that the ground safety locks are installed on the landing gear (Ref. TASK 32-00-00-481-001).

 (3)
 Install the SAFETY DEVICE - RAT (98D29208246001) (Ref. TASK 29-22-00-860-007).

 (4)
 Make sure that the slats/flaps are fully retracted (Ref. TASK 27-80-00-866-005) (Ref. TASK 27-50-00-866-009).

 (5)
 Install the TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER (98D27803500001) on the slat/flap control lever.

 (6)
 Make sure that the external power connector is not connected to the aircraft receptacle.

 (7)
 Put warning notice(s) on the access door 121AL to tell persons not to use the external power receptacle.

 (8)
 On the panel 400VU:

 -make sure that the landing-gear control-lever 6GA is in the DOWN position
 -put a warning notice in position to tell persons not to operate the landing gear.

 (9)
 Put a warning notice on the flap/slat control lever to tell persons not to operate the flap/slat system.
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM LANDING GEAR 起落架4(72)