C. Safety Precautions
(1) Make sure that the warning notices are in position to tell persons not to pressurize the Green hydraulic system: - on the panel 40VU in the cockpit, - on the ground service panel of the Green hydraulic system.
Subtask 32-31-44-560-050
D. Preparation of the Replacement Component
(Ref. Fig. 401/TASK 32-31-44-991-001)
(1) View D
(a)
Remove and discard the cotter pin (32) from the removed uplock assembly (8).
(b)
Remove the nut (31), the washer (30), the bolt (39) and remove the lever (29) from the uplock assembly (8).
WARNING : OBEY THE MANUFACTURER'S INSTRUCTIONS WHEN YOU USE THE
_______
SPECIAL MATERIAL.
THIS MATERIAL IS DANGEROUS.
(c)
Apply SPECIAL MATERIALS (Material No. 05-002) to the splined shaft of the new uplock assembly (8), the bolt (39) and the washer (30).
(d)
Put the lever (29) in position on the splined shaft of the uplock assembly (8). Make sure that the master splines are aligned.
(e)
Install the bolt (39), the washer (30) and the nut (31).
(f)
Safety the nut (31) with a new cotter pin (32).
(2)
Make sure that the dimension "X" of the new component is the same of that retained from the removed component. (Ref. Fig. 402/TASK 32-31-44-991-002)
(3)
If necessary adjust to "Dimension X":
(a)
Cut and remove the lock wire from the eye end-lock nut.
(b)
Loosen the eye end-lock nut.
