-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
-make sure that the MODE switch (6KS) is in the NORM (center) position
-put the MASTER 2 switch to the ON position.
19. On the MCDU:
-push in the key adjacent to the DISPLAY NON-MONITORING TEST RESULTS indication
-make sure that the indication FRV, J8 ECU is not shown
-push in the key adjacent to the RETURN indication.
20.
On the panel 115VU, put the MASTER 2 switch to the OFF position.
21.
On the panel 50VU:
-push in the ENG/FADEC GND PWR 2 P/BSW.
22.
On the MCDU:
-push in the key adjacent to the RETURN indication until the SYSTEM REPORT/TEST page is shown -this indication is shown:
***** WARNING *****
***** TEST ACTIVE *****
-when the test has stopped this indication is shown: A NON-MONITORING TEST WAS PERFORMED DUE TO INSUFFICIENT STARTER AIR PRESSURE OR DUE TO A STARTER AIR VALVE FAILURE
-
the test results are shown
-
the TEST COMPLETE page is shown.
-
the ON light of the ENG/FADEC GND PWR2 P/BSW goes off.
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-21-00Page 408 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
-
push in the key adjacent to - the FUEL page is shown
the FUEL indication
-
push in the NEXT PAGE key - the second FUEL page is shown
-
push in the key adjacent to - the FLSS STATUS page is shown
the FLSS STATUS indication
-make sure that none of these
messages are shown:
L SURGE SENSOR 28QJ1
R SURGE SENSOR 28QJ2
L INN TEMP SENSOR 29QJ1
R INN TEMP SENSOR 29QJ2
L OUT TEMP SENSOR 30QJ1
R OUT TEMP SENSOR 30QJ2
L LO LEVEL SENSOR 38QJ1
R LO LEVEL SENSOR 38QJ2
-
push in the key adjacent to
RETURN until the CFDS MENU
page is shown
-
push in the MCDU MENU key. - the MCDU MENU is shown.
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-21-00Page 409 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1 **ON A/C 301-399,
Subtask 28-21-00-040-050-A
A. Check Operation of the Recirculation System When Main Fuel Pump 2 does not Operate
(1) Do this test:
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1.
On the MCDU, get access to the ENG page (Ref. TASK 31-32-00-860-012).
2.
On the panel 50VU, make sure that the ENG/FADEC GND PWR/1 pushbutton switch (P/BSW) is released out.
3.
On the MCDU:
-
push in the key adjacent to the FADEC 1A indication
-
push in the key adjacent to the FADEC TEST indication
-
push in the key adjacent to the PUSH BUTTON TO START TEST> indication.
NOTE : The tests that follow are
____ usually done without an air pressure supply to the engine starter motor (non-engine motor test). If air pressure is supplied, the engine fan blades will turn during
On the panel 50VU, the ENG/FADEC GNDPWR/1 P/BSW ON light is on.
-
the ENGINE 1 MAIN MENU is shown
-
the FADEC TEST ENGINE 1 CHANNEL Apage is shown
-this indication is shown:PUT THE MODE SELECTORSWITCH TO <NORM> PLACE THE MASTER LEVER SWITCH TO <ON>
1EFF : 301-399, 1 28-21-00Page 410 1 1 May 01/05R 1 1 1CES 1
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
R R R the tests. You must obey the applicable safety precautions.
R R R R 4. On the panel 115VU: - make sure that the MODE switch (6KS) is in the NORM (center) position
R R R R R R R R R R R R R - put the MASTER 1 switch to the ON position.
R 5. On the MCDU:
R R R - push in the key adjacent to the DISPLAY NON-MONITORING TEST RESULTS indication
R R R - make sure that the indication J7, FRV (SOL1), ECU is not shown
R R - push in the key adjacent to the RETURN indication.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM FUEL 燃油2(110)
