-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------- push the BLEED pushbutton - the BLEED page comes on. switch. - the ram air inlet symbol is closed.
5. Close-up________
Subtask 21-31-00-860-060
A. Put the aircraft back to its initial configuration.
R (1) Do the ADIRS stop procedure (Ref. TASK 34-10-00-860-005).
R (2) Do the EIS stop procedure (Ref. TASK 31-60-00-860-002).
R (3) De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002).
TASK 21-31-00-710-006 Operational Test of Safety Valve Position Indication WARNING : MAKE SURE THAT ALL THE CIRCUITS IN MAINTENANCE ARE ISOLATED BEFORE
_______ YOU SUPPLY ELECTRICAL POWER TO THE AIRCRAFT.
NOTE : For the test procedure two persons are required. One person must operate
____ the safety valve, the other person must monitor the ECAM upper and lower display units and the panels 130VU and 132VU in the cockpit.
1.
Reason for the Job
__________________
Refer to the MPD TASK: 213100-07
2.
Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
from the External Power 31-60-00-860-001 EIS Start Procedure 31-60-00-860-002 EIS Stop Procedure
3. Job Set-up
__________ Subtask 21-31-00-010-050
A. Get access to the safety valves through the rear galley wall. Subtask 21-31-00-865-056
B. Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
49VU AIR COND/CAB/PRESS/CTL1 1HL D09 122VU AIR COND/CAB PRESS/CTL/MAN 3HL Y23 122VU AIR COND/CAB PRESS/CTL/2 2HL Y22 Subtask 21-31-00-860-061
C. Aircraft Maintenance Configuration
(1)
Energize the aircraft electrical circuits
(Ref. TASK 24-41-00-861-002).
(2)
Do the EIS start procedure (Upper ECAM DU and lower ECAM DU only) (Ref. TASK 31-60-00-860-001).
(3)
Make sure that the PRESS page is shown on the ECAM lower display unit.
4. Procedure
_________ Subtask 21-31-00-710-056
A. Operaional Test of the Safety Valve Position Indication NOTE : The test procedure is the same for the safety valves 6HL and 7HL.
____
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On one of the safety valves: On the ECAM lower display unit:
-push the valve diaphragm until - the green SAFETY indication changes
the spring is compressed. to amber and the valve symbol opens and changes to amber.
On the panels 130VU and 132VU:
-
the amber light in the two MASTER CAUTION pushbutton switches come on.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM AIR CONDITIONING 空调 3(15)