钻石40飞机维护手册 DA 40 SERIES AMM 6(42)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

The propeller turns in a clockwise direction when viewed form the cockpit.
A. Power Plant Components
The power plant has these components installed:
) Cowling
The power plant has a top and bottom engine cowling. The two halves attach to each other and to the airframe with camloc quick release fasteners. The top cowling has one small access panel for the engine oil filler and dipstick. The bottom cowling has two large cooling air intakes and one air intake for the engine air filter.
) Engine Mount
The engine mount attaches to the firewall at five locations. Tubular steel makes the mounting frame. The engine attaches to the engine mount with shock-mounts. Rubber and metal bushings make the engine shock-mounts.
) Electrical Harness
Electrical cables go through the firewall to connect to the engine. They give electrical supply to the engine starter motor, ignition system and engine sensors. Electrical cables from the generator supply electrical power to the airplane electrical system.
Doc # 6.02.01 Page 3
71-02-00
DA 40 Series AMM
DA 40 F

B. Air Intakes
The bottom cowling has these air intakes: ) The intake on the front left face of the bottom cowling supplies cooling air for the engine. ) The intake on the front right face of the bottom cowling has three outlets: @ An outlet which supplies additional cool air to the engine. ) Engine air intake. This intake is located in the lower center of the cowling and supplies air to the engine air filter. @  An outlet which supplies cooling air through integral ducting to the oil cooler. @ An outlet which connects to a flexible hose which supplies cooling air to the cabin heat system and to the battery.
C. Engine Drain Pipes
The engine has these drain pipes:
) Engine driven fuel pump drain.
) Induction manifold drain.

DA 40 Series AMM

Engine Specification
DA 40 F

Engine manufacturer.  Lycoming 
Engine model.  O-360-A4M 
Engine operating limits: Rated output power. Rated output rotation speed during take-off and climb. Max. continuous rotation speed.  180 HP (134.2 kW) 2700 RPM 2700 RPM 
Ground run-up limits: Ground idle speed.  740 ± 20 RPM 
Oil pressure: Minimum Normal Maximum  25 psi 55 - 95 psi 97 psi 
Fuel pressure: Minimum Normal Maximum  1 psi 2 - 7 psi 8 psi 
Oil temperature: Minimum (not for continuous operation). Normal Maximum  149 °F 149 - 230 °F 245 °F 
Cylinder head temperature: Minimum Normal Maximum  150 °F 150 - 475 °F 500 °F 
Fuel grade:  AVGAS 100 or 100LL 
Oil specification (see Section 12-10):  Refer to Lycoming Operator's Manual. 

Doc # 6.02.01 Page 5
71-02-00
DA 40 Series AMM
DA 40 F

Intentionally left blank
DA 40 F

Trouble-Shooting
1. General
The table below lists the defects you could have with the power plant. It does not give trouble shooting data for the engine or the engine systems. Refer to the Lycoming Operator's Manual for engine and engine system trouble-shooting.
WARNING:  YOU MUST BE CAREFUL WHEN YOU DO POWER PLANT TROUBLE SHOOTING. OPERATION OF A DAMAGED ENGINE CAN CAUSE MORE DAMAGE TO THE ENGINE. THIS CAN CAUSE INJURY TO PERSONNEL.
If you have the trouble detailed in the Trouble column read across to the Possible Cause column. Then do the repair given in the Repair column.
Trouble  Possible Cause  Repair 
Engine vibration.  Damaged shock mounts.  Replace the shock mounts. 
Engine does not produce full power.  Engine air inlet blocked.  Examine air inlet. Examine/Replace the air filter. 

Doc # 6.02.01  Page 101
71-02-00
DA 40 Series AMM
DA 40 F

Intentionally left blank
DA 40 F
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：钻石40飞机维护手册 DA 40 SERIES AMM 6(42)