钻石40飞机维护手册 DA 40 SERIES AMM 6(24)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

(1)  Make sure that the engine is safe: S Set the ELECTRIC MASTER key switch to OFF. S Set the ENGINE MASTER switch to OFF. S Set the power lever to IDLE. 
(2)  Remove the engine top cowling.  Refer to Section 71-11. 
(3)  Disconnect the airplane main battery.  Refer to Section 24-34. 
(4)  Remove the instrument panel cover.  Refer to Section 25-10. 
(5)  Release the retaining nut from the cockpit side of the ELECTRIC MASTER key switch. 
(6)  Move the ELECTRIC MASTER key switch towards the front of the airplane. 
(7)  Disconnect the cables from the ELECTRIC MASTER key switch  Make a note of the position of the cables. 
(8)  Remove the ELECTRIC MASTER key switch from the airplane. 

%

Doc # 6.02.01 Page 201
Rev. 4 09 Jan 2003

80-01-00
AMM

% B. Install the ELECTRIC MASTER Key Switch % %
% % % %
% % % % %
% % %
%
%
% %
% %
%
%
%

DA 40 Series

Detail Steps/Work Items  Key Items/References 
WARNING: MAKE SURE THAT THE ENGINE IS SAFE BEFORE YOU DO ANY WORK ON THE STARTER SYSTEM. IF THE ENGINE STARTS THE PROPELLER CAN CAUSE INJURY OR DEATH. 
(1)  Make sure that the engine is safe: S Set the ELECTRIC MASTER key switch to OFF. S Set the ENGINE MASTER switch to OFF. S Set the power lever to IDLE. 
(2)  Put the ELECTRIC MASTER key switch in position between the instrument panel and the firewall. 
(3)  Connect the cables to the ELECTRIC MASTER key switch  Refer to the wiring diagrams and the notes you made during removal. 
(4)  Move the ELECTRIC MASTER key switch into position in the instrument panel. 
(5)  Install the retaining nut to the cockpit side of the ELECTRIC MASTER key switch. 
(6)  Install the instrument panel cover.  Refer to Section 25-10. 
(7)  Connect the airplane main battery.  Refer to Section 24-34. 
(8)  Install the engine top cowling.  Refer to Section 71-11. 
(9)  Do an engine ground run-up.  Refer to Section 71-01. 

%

80-01-00
Starting
AMM

% 3. Remove/Install the ENGINE MASTER Switch
%
%

%
%
%
%
%
%
%
%
%
%
%
%

%

%
%
%

%
%

% A. Remove the ENGINE MASTER Switch %

Detail Steps/Work Items  Key Items/References 
WARNING: MAKE SURE THAT THE ENGINE IS SAFE BEFORE YOU DO ANY WORK ON THE STARTER SYSTEM. IF THE ENGINE STARTS THE PROPELLER CAN CAUSE INJURY OR DEATH. 
(1)  Make sure that the engine is safe: S Set the ELECTRIC MASTER key switch to OFF. S Set the ENGINE MASTER switch to OFF. S Set the power lever to IDLE. 
(2)  Remove the engine top cowling.  Refer to Section 71-11. 
(3)  Disconnect the airplane main battery.  Refer to Section 24-34. 
(4)  Remove the instrument panel cover.  Refer to Section 25-10. 
(5)  Release the retaining nut from the cockpit side of the ENGINE MASTER switch. 
(6)  Move the ENGINE MASTER switch towards the front of the airplane. 
(7)  Disconnect the cables from the ENGINE MASTER switch  Make a note of the position of the cables. 
(8)  Remove the ENGINE MASTER switch from the airplane. 

%

Doc # 6.02.01 Page 203
Rev. 4 09 Jan 2003

80-01-00
AMM

% B. Install the ENGINE MASTER Switch % %
% % % %
% % % % %
% %
%
%
% %
% %
%
%
%

DA 40 Series

Detail Steps/Work Items  Key Items/References 
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：钻石40飞机维护手册 DA 40 SERIES AMM 6(24)