- replace the ACTUATOR-AIR OUTLET FLAP (29HH) (Ref. AMM TASK 21-61-52-000-001) and (Ref. AMM TASK 21-61-52-400-001).
(1) If the fault continues:
- do a check and repair the wiring (Ref. ASM 21-61/02) from:
- the ACTUATOR (29HH) to the PC 2 (27HH) and,
- the ACTUATOR (29HH) to ground.
(2) If the fault continues:
- replace the CONTROLLER-PACK 2 TEMP (27HH) (Ref. AMM TASK 21-61-34-000-001) and (Ref. AMM TASK 21-61-34-400-001).
D. Do the test as given in the Para. 3.A.
5. Close-up
________
A. Put the aircraft back to its initial configuration.
**ON A/C ALL
TASK 21-61-00-810-816
Pack 1 Turbine Bypass Valve Fault
1. Possible Causes
_______________
- VALVE-TURBINE BYPASS (10HH)
- wiring
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 21-61-00-710-001 Operational Test of the Pack Temperature-Control
System
AMM 21-61-53-000-001 Removal of the Bypass Valve 10HH (30HH)
AMM 21-61-53-400-001 Installation of the Bypass Valve 10HH (30HH)
ASM 21-61/04
3. Fault Confirmation
__________________ R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
A. Do the operational test of the pack temperature-control system (Ref. AMM TASK 21-61-00-710-001).
NOTE : If a fault is detected, the PC gives a fault code for shop
____ maintenance in addition to the related CFDS message(s) (refer to TSM chapter 21-63-00, page block 301).
R **ON A/C 401-499,
A. Do the operational test of the pack temperature-control system (Ref. AMM TASK 21-61-00-710-001).
**ON A/C ALL
4. Fault Isolation
_______________
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
A. If the test gives the maintenance message TEST OK, but the POST FLIGHT REPORT and/or the PREVIOUS LEG REPORT gives the maintenance message P1 BYPASS VALVE:
- no further maintenance action is necessary.
NOTE : If it is reported that a bypass valve fault has ocurred several
____
times in flight:
- replace the VALVE-TURBINE BYPASS (10HH) (Ref. AMM TASK 21-61-53-000-001) and (Ref. AMM TASK 21-61-53-400-001).
R **ON A/C 401-499,
A. If the test gives the maintenance message TEST OK, but the POST FLIGHT REPORT and/or the PREVIOUS LEG REPORT gives the maintenance message P1 BY PASS VALVE(10HH):
- no further maintenance action is necessary.
NOTE : If it is reported that a bypass valve fault has ocurred several
____
times in flight:
- replace the VALVE-TURBINE BYPASS (10HH) (Ref. AMM TASK 21-61-53-000-001) and (Ref. AMM TASK 21-61-53-400-001).
**ON A/C 001-003, 051-054,
B. If the test gives the maintenance message P1 BYPASS VALVE:
- replace the VALVE-TURBINE BYPASS (10HH) (Ref. AMM TASK 21-61-53-000-001) and (Ref. AMM TASK 21-61-53-400-001).
(1) If the fault continues:
- do a check and repair the wiring (Ref. ASM 21-61/04) from:
- the VALVE (10HH) to the PC 1 (7HH) and,
- the VALVE (10HH) to ground.
R **ON A/C 004-049, 055-099, 101-149, 151-199, 201-299, 301-399,
B. If the test gives the maintenance message P1 BYPASS VALVE:
- replace the VALVE-TURBINE BYPASS (10HH) (Ref. AMM TASK 21-61-53-000-001) and (Ref. AMM TASK 21-61-53-400-001).
(1) If the fault continues:
- do a check and repair the wiring (Ref. ASM 21-61/04) from:
- the VALVE (10HH) to the PC 1 (7HH) and,
- the VALVE (10HH) to ground.
R **ON A/C 401-499,
B. If the test gives the maintenance message P1 BY PASS VALVE(10HH):
- replace the VALVE-TURBINE BYPASS (10HH) (Ref. AMM TASK 21-61-53-000-001) and (Ref. AMM TASK 21-61-53-400-001).
(1) If the fault continues:
- do a check and repair the wiring (Ref. ASM 21-61/04) from:
- the VALVE (10HH) to the ACSC1 (47HH) and,
- the VALVE (10HH) to ground.
**ON A/C ALL
C. Do the test as given in the Para. 3.A.
5. Close-up
________
A. Put the aircraft back to its initial configuration.
TASK 21-61-00-810-817
Pack 2 Turbine Bypass Valve Fault
1. Possible Causes
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320 Trouble Shooting Manual 排故手册 AIR CONDITIONING 空调2(35)
