PC 2 (27HH) connector AB/14A and GND (Ref. ASM 21-61/01).
(2) If the fault continues:
- a check and repair if necessary the wiring of the signal: ARINC 429 XTR (P) from the ZC (8HK) to the PC 2 (27HH), ARINC 429 XTR (S) from the ZC (8HK) to the PC 2 (27HH), ARINC 429 RCV (S) from the ZC (8HK) to the PC 2 (27HH) (Ref. ASM 21-63/02).
(3) If the fault continues:
- do the trouble shooting procedures for the pack 2 electrical component with short circuit (Ref. TASK 21-61-00-810-821).
R **ON A/C 401-499,
A. If the test gives the maintenance message TEST FAILED with the fault code (6E):
- do a check for a ground signal at the ACSC1 (47HH)AA pin 9B (Ref. ASM 21-61/01).
(1) If there is no ground signal:
- do the BITE test of the landing gear (Ref. AMM TASK 32-69-00-740-001).
(a) If the test gives a different maintenance message, you can find the related trouble shooting procedure in the applicable Page Block 101.
(b) If the fault continues:
- do a check and repair the wiring (Ref. ASM 216101) from:
- the ACSC2 (57HH) to the LGCIU 2.
(2) If the fault continues:
- do a check and repair the wiring (Ref. ASM 2151S01) from:
- the ACSC2 (57HH) to the FCS (24HB).
B. If the test gives the maintenance message ACSC2 (57HH):
- replace the CONT-AIR COND SYSTEM 2 (57HH) (Ref. AMM TASK 21-61-34-000-002) and (Ref. AMM TASK 21-61-34-400-002).
(1) If the fault continues:
- do a check and repair the wiring (Ref. ASM 21-61/01) from:
- the ACSC2 (57HH) to the CB (53HH),
- the ACSC2 (57HH) to the CB (54HH) and,
- the ACSC2 (57HH) to ground.
(2) If the fault continues:
- do the trouble shooting procedures for the pack 2 electrical component with short circuit (Ref. TASK 21-61-00-810-821).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞21-61-00∞∞∞∞∞∞∞∞∞∞Page 242
Aug 01/05 CES
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
C. If the test gives the maintenance message NO 28V ON PACK 2 MAIN:
- do a check and repair the wiring between: PC 2 (27HH) connector AA/8C and CB (23HH), PC 2 (27HH) connector AA/8D and GND (Ref. ASM 21-61/01).
D. If the test gives the maintenance message NO 28V ON PACK 2 SECD:
- do a check and repair the wiring between: PC 2 (27HH) connector AB/9A and CB (24HH), PC 2 (27HH) connector AB/9B and GND (Ref. ASM 21-61/01).
**ON A/C ALL
E. Do the test as given in the Para. 3.A.
5. Close-up
________
A. Put the aircraft back to its initial configuration.
TASK 21-61-00-810-807
Pack 1 and Pack 2 Inoperative
1. Possible Causes
_______________
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
21-61-00-810-801 Pack 1 Overheat 21-61-00-810-802 Pack 2 Overheat 21-61-00-810-803 Pack 1 Fault 21-61-00-810-804 Pack 2 Fault AMM 21-61-00-710-001 Operational Test of the Pack Temperature-Control
System
3. Fault Confirmation
__________________
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
A. Do the operational test of the pack temperature-control system (Ref. AMM TASK 21-61-00-710-001).
NOTE : If a fault is detected, the PC gives a fault code for shop
____ maintenance in addition to the related CFDS message(s) (refer to TSM chapter 21-63-00, page block 301).
R **ON A/C 401-499,
A. Do the operational test of the pack temperature-control system (Ref. AMM TASK 21-61-00-710-001).
**ON A/C ALL
4. Fault Isolation
_______________
A. If the FAULT legend on the pushbutton switch PACK 1 and the OFF legend on the pushbutton switch PACK 2, which are installed on the panel 30VU, come on:
- do the trouble shooting procedures for the pack 1 fault (Ref. TASK 21-61-00-810-803).
- make sure that the pushbutton switch PACK 2, which is installed on the panel 30VU, is in the on position (with the FAULT and OFF legends off). 中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址：A320 Trouble Shooting Manual 排故手册 AIR CONDITIONING 空调2(29)
