R Shrinkable Mouldings - Installation Procedure
R E0096, ABS0266, ABS0312, E0056, DAN218, DAN299, DAN301 and DAN302 Figure 002
20-33-34 Page 520-33-34 Page 6
R ____NOTE : 90. shrinkable mouldings contain a memory and should be at
R a 90. angle after shrinking. It can be necessary during
R the shrinking operation to hold the outlet of the moulding
R in its 90. position until it is cool.
R (b) When delivery-coated with adhesive sealant
R - Roughen the external side of the shrunken sleeve in the bonding
R area with emery cloth (grain 320 or finer).
R - Clean the roughened areas with a cleaning agent.
R - Install the moulding on the shrunken sleeve and the rear
R connector.
R - Select the applicable shrinking tool.
R - Install the applicable reflector on the shrinking tool
R according to the dimensions of the part to be shrunk.
R - Start shrinking at the connector (You must start shrinking at
R the point where a specified position is required).
R ____NOTE : During shrinking, turn the moulding in the heat flow, if
R possible, to obtain equal distribution of temperature.
R - Do not let the harness touch the reflector during shrinking.
R - Shrinking is completed when the mouldings fit closely and when
R the form is flush.
R - If used, remove any unwanted sealant immediately with a clean
R cloth.
R ____NOTE : 90. shrinkable mouldings contain a memory and should be at
R a 90. angle after shrinking. It can be necessary during
R the shrinking operation to hold the outlet of the moulding
R in its 90. position until it is cool.
R (2) Moulding boot (ABS0312, E0056, DAN301 and DAN302)
R - Select the applicable shrinkable mouldings and the correct size.
R - Install the moulding on the harness.
R - Select the applicable shrinking tool.
R - Install the applicable reflector on the shrinking tool according to
R the dimensions of the part to be shrunk.
R - Start shrinking at the point where a specified position is
R required).
R - Do not let the harness touch the reflector during shrinking.
R - Shrinking is completed when the mouldings fit closely and when the
R form is flush.
R ____NOTE : During shrinking, turn the moulding in the heat flow, if
R possible, to obtain equal distribution of temperature.
______________________________________
ATTACHMENT - DESCRIPTION AND OPERATION
_______
1. General The chapters that follow give the general description and requirements related to the elements which attach, route and install the wiring without
R damage to the aircraft. These elements are separated into several families.
_________________________2. Structure of the Chapters
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320 ESPM Electrical Standard Practices Manual 2(66)
