R EFF : 001-049, 101-105, 107-107, 151-199, 49-11-11Page 422 201-210, Config-2 Aug 01/05
CES
(2) Removal of the APU from the APU mount vibration-isolators CAUTION : MAKE SURE THAT THE THREE ATTACHMENT NUTS ARE REMOVED AND
_______ THAT THE APU CAN MOVE DOWN FREELY. IF YOU DO NOT DO THIS, YOU CAN CAUSE DAMAGE TO THE TIE RODS WHEN YOU LOWER THE APU.
CAUTION : MAKE SURE THAT ALL PLUMBING IS FREE FROM OBSTRUCTION.
_______
(a) Remove the APU from the APU mount vibration-isolators and lower it carefully from the APU compartment.
(3) Attachment of the APU to the SUPPORT FRAME - APU. CAUTION : MAKE SURE THAT ALL PLUMBING IS FREE FROM OBSTRUCTION.
_______
(a)
Attach the APU to the SUPPORT FRAME - APU. NOTE : Make sure that the pip-pins are fully engaged in the
____ brackets of the APU support frame and the APU. Make sure that the screw at the rear of the APU support frame is fully engaged in the attachment plate and the APU.
(b)
Disconnect the HOIST - MINILIFT from the APU (Ref. TASK 49-00-00-080-003).
(c)
Put a blanking cover on the APU exhaust flange. NOTE : If you will not install the APU, you must install the
____ components of the kit for the FLIGHT WITHOUT APU.
(4) Disconnection of replacement Component
(a)
Remove the Generator (80) (Ref. TASK 24-23-51-000-001).
(b)
Remove the FWD and AFT APU mount brackets (46) (Ref. TASK 49-12-54-000-003).
(c)
Remove the APU LP Switch 5030QM (Ref. TASK 28-22-14-000-001). NOTE : Keep these parts into a container for replacement at the
____
new component.
R **ON A/C 001-049, 101-105, 107-107, 151-199, 201-210,
TASK 49-11-11-400-004
Installation of the Power Plant (APU) (131-9(A))
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s)
No specific fiber-bristled brush
No specific red locking varnish
No specific container 1.0 l (0.2641 USgal)
No specific access platform 3.5 m (11 ft. 6 in.)
No specific Torque Wrench : range 0.00 to 1.20 m.daN
(0.00 to 9.00 lbf.ft)
No specific Torque Wrench : range 0.20 to 3.60 m.daN
(2.00 to 26.00 lbf.ft) No specific Torque Wrench : range 1.00 to 10.00 m.daN
(8.00 to 75.00 lbf.ft) 98A49107504001 3 PROTECTOR - THREADS, APU MOUNTING BOLTS 98D49207527000 1 SUPPORT FRAME - APU
R EFF : 001-049, 101-105, 107-107, 151-199, 49-11-11Page 424 201-210, Config-2 Aug 01/05
CES
INTENTIONALLY BLANK
INTENTIONALLY BLANK
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 03-002
Material No. 06-001A
Material No. 11-001
Material No. 15-005
Material No. 19-010
GB DEF-STAN 91-101 LUBRICATING OIL TURBINE ENGINE SYNT BASE (Ref. 20-31-00)USA MIL-L-23398 SOLID FILM LUBRICANT AIR DRYING (Ref. 20-31-00)USA MIL-D-16791 TYPE I DETERGENT (Ref. 20-31-00)AIB TN 10138 TYPE I GRADE 2 CORROSION PREVENTIVE TEMPORARY PROTECTIVE COMPOUND (Ref. 20-31-00)USA AMS 5687 LOCKWIRE STAINLESS STEEL ANNEALED 0.8MM DIA (Ref. 20-31-00)
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
20-21-11-911-001 20-28-00-912-004 21-00-00-100-001 21-00-00-615-001 21-00-00-615-002 24-23-51-400-001 Tightening Torques for Standard Threaded FastenersElectrical Bonding of Components With Conductive Bolts and Screws and Bonding Straps in the Fuselage and in the Wings (this does not include the tanks)-Cleaning of Special Components in the Environmental Control System (ECS)Decontamination of the Environmental Control System (ECS) when the Temperature is below 24 deg.C (APU)Decontamination of the Environmental Control System (ECS) when the Temperature is above 24 deg.C (APU)Installation of the APU Generator 8XS
24-42-00-861-001 Energize the Ground Service Network from the External Power
24-42-00-862-001 De-energize the Ground Service Network Supplied from the External Power
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM 机载辅助动力 AIRBORNE AUXILIARY POWER2(44)
