• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-03-24 08:37来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 (6) Loosen the union nut (15) and disconnect the suction pipe (16) from the pump (6). 
R R  (7) Remove and discard the O-ring (28) from the union nut (15). Install a blanking plug in the disconnected line end. 
R  (8) Loosen the union nut (3) and disconnect the case drain pipe (2) from the pump (6). Install a blanking plug in the disconnected line end. 
R  (9) Loosen the union nut (12) and disconnect the pressure pipe (13) from the pump (6). Install a blanking plug in the disconnected line end. 
R  (10) Loosen the union nut (11) and disconnect the seal drain pipe (10) from the pump (6). 
R R (11) Put blanking caps in the open ports of the pump. 

 

R  Blue Electric Pump Figure 401/TASK 29-12-51-991-001
 1EFF : 1 1 1CES  ALL  1 111 29-12-51 Page 404 May 01/05

 

R  (12) Hold the pump (6) and remove it as follows:
 (a) Remove and discard the four nuts (14).
 NOTE : If new nuts (14) are not available, you can keep them, but____ do not use them more than three times.
 (b) Disconnect the bonding jumper (17).
 (c) Remove the washer (19). 
R  (d) Remove the pump (6) with the attachment bracket (1). 
R  (13) Remove the four bolts (18).

 

 TASK 29-12-51-400-001
 Installation of the Electric Pump (2075GJ)
 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______
 START A TASK ON OR NEAR:

 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS


 -COMPONENTS THAT MOVE.
 WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROL SURFACES ARE
_______
 CLEAR BEFORE YOU PRESSURIZE/DEPRESSURIZE A HYDRAULIC SYSTEM.

 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific container
 No specific warning notices R No specific Torque Wrench : range 0.00 to 1.20 m.daN R (0.00 to 9.00 lbf.ft)
 No specific Torque Wrench : range 0.20 to 3.60 m.daN
 (2.00 to 26.00 lbf.ft) No specific Torque Wrench : range 1.00 to 10.00 m.daN
 (8.00
 to 75.00 lbf.ft) No specific Torque Wrench : range 2.00 to 20.00 m.daN

 (15.00 to 150.00 lbf.ft)

 B.
 Consumable Materials

 


 -------------------------------------------------------------------------------
REFERENCE  DESIGNATION
 -------------------------------------------------------------------------------
Material No. 02-003  F NSA 307110 TYPE 4
 HYDRAULIC FLUID (PHOSPHATE ESTER BASE)
 (Ref. 20-31-00)

 Material No. 19-009  USA AMS 5687
 LOCKWIRE STAINLESS STEEL ANNEALED 0.5MM DIA
 (Ref. 20-31-00)

 Material No. 19-010  USA AMS 5687
 LOCKWIRE STAINLESS STEEL ANNEALED 0.8MM DIA
 (Ref. 20-31-00)

 C. Expendable Parts
 -------------------------------------------------------------------------------
FIG.ITEM |DESIGNATION  |IPC-CSN
 -------------------------------------------------------------------------------
R 14 nuts  29-12-03 09 -020
 D. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE  DESIGNATION
 -------------------------------------------------------------------------------
12-12-29-611-001 Fill the Hydraulic Fluid Reservoir with a Hand Pump 24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied from the External Power 29-00-00-864-001 Put the Related Hydraulic System in the Depressurized Configuration before Maintenance Action 29-00-00-870-008 Bleeding Procedure of the Blue Hydraulic System Upstream of the Blue E-Pump 29-00-00-870-009 Bleeding Procedure of the Blue Hydraulic System
 Downstream of the Blue E-Pump 29-00-00-910-002 Safety Procedures of the Hydraulic System 29-14-00-614-001 Depressurization of the Hydraulic Reservoirs 29-14-00-614-002 Pressurization of the Hydraulic Reservoirs through
 the Ground Connector
 31-60-00-860-001 EIS Start Procedure
 31-60-00-860-002 EIS Stop Procedure

 

 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM HYDRAULIC POWER 液压3(88)