• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-03-24 08:37来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 A. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU HYD/HYD PWR/B WARN/& CTL 2702GJ C12
 49VU HYD/HYD/PRESS/XMTR 1841GN C11 121VU HYDRAULIC/SOL VALVES/G/Y/B/LEAK/TST 1881GP N35 123VU B HYD/ELEC PUMP 2701GJ AB09 Subtask 29-12-14-010-050


 B. Get Access
 (1)
 Open the access door 197EB.

 (2)
 Open the left main door of the main gear (Ref. TASK 32-12-00-010-001).


 (3)
 Open the access door 195BB.
 Subtask 29-12-14-860-051


 C.
 Aircraft Maintenance Configuration
 WARNING : OBEY THE HYDRAULIC SAFETY PROCEDURES.

 

_______
 (1)
 Obey the hydraulic safety procedures (Ref. TASK 29-00-00-910-002).

 (2)
 Put the warning notices in position to tell persons not to pressurize the Blue hydraulic system:

 -in the cockpit on the hydraulic section 40VU of the overhead panel, - on the ground service panel of the Blue hydraulic system.

 (3)
 Make sure that the Blue hydraulic system is depressurized and put it in the maintenance configuration. (Ref. TASK 29-00-00-864-001).

 (4)
 Depressurize the reservoir of the Blue hydraulic system (Ref. TASK 29-14-00-614-001).

 (5)
 Put the containers below the HP manifold of the Blue hydraulic system and the ground leakage-measurement manifold (2146GM) to collect unwanted hydraulic fluid.


 4. Procedure
_________ R **ON A/C 001-049, 051-058, 101-101,
 (Ref. Fig. 401/TASK 29-12-14-991-001) R **ON A/C 059-061, 102-105, 201-203,
 (Ref. Fig. 401A/TASK 29-12-14-991-001-A)


 HP Manifold - Sheet 1
 Figure 401/TASK 29-12-14-991-001

R 1EFF : 001-049, 051-058, 101-101, 1 29-12-14Page 404 1 1 May 01/05 1 1 1CES 1


 HP Manifold - Sheet 1 Figure 401A/TASK 29-12-14-991-001-A
R 1EFF : 059-061, 102-105, 201-203, 1 29-12-14Page 405 1 1 May 01/05 1 1 1CES 1R **ON A/C 062-099, 106-149, 151-199, 204-299, 301-399, 401-499,

 

 (Ref. Fig. 401B/TASK 29-12-14-991-001-B)
 **ON A/C 001-049, 051-058, 101-101,

 (Ref. Fig. 402/TASK 29-12-14-991-002) R **ON A/C 059-099, 102-149, 151-199, 201-299, 301-399, 401-499,
 (Ref. Fig. 402A/TASK 29-12-14-991-002-A)
 **ON A/C 001-049, 051-058, 101-101,

 Subtask 29-12-14-020-050
 A. Removal of the HP Manifold CAUTION : USE A SECOND WRENCH TO APPLY COUNTERTORQUE TO THE UNION WHEN
_______ YOU DISCONNECT/CONNECT HYDRAULIC LINES ON UNIONS. IF YOU USE THE SECOND WRENCH, YOU WILL NOT LOOSEN OR TIGHTEN THE UNION TOO MUCH.
 (1)
 Disconnect the electrical connectors (20),(29),(32),(33).

 (2)
 Put blanking caps on the disconnected electrical connectors.

 (3)
 Remove the nut (19), the bolt (15) and the washer (16) and disconnect the bonding jumper (17) from the structural attachment (18).

 (4)
 Cut and remove the tie wraps as necessary.

 (5)
 Remove the cable clamps as necessary.

 (6)
 Loosen the pipe end-fittings (47),(74) and remove the pipe (48).

 (7)
 Loosen the pipe end-fittings (6),(77) and remove the pipe (5).

 (8)
 Loosen the pipe end-fittings (10),(72) and remove the pipe (9).

 (9)
 Loosen the pipe end-fittings (59),(75) and remove the pipe (60).


 (10) Loosen the pipe end-fittings (56),(70) and remove the pipe (57).


 HP Manifold - Sheet 1 Figure 401B/TASK 29-12-14-991-001-B
R 1EFF : 062-099, 106-149, 151-199, 204-299, 1 29-12-14Page 407 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1


 HP Manifold - Sheet 2
 Figure 402/TASK 29-12-14-991-002

R 1EFF : 001-049, 051-058, 101-101, 1 29-12-14Page 408 1 1 May 01/05 1 1 1CES 1


 HP Manifold - Sheet 2 Figure 402A/TASK 29-12-14-991-002-A
R 1EFF : 059-099, 102-149, 151-199, 201-299, 1 29-12-14Page 409 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1


 (11)
 Loosen the pipe end-fittings (65),(78) and remove the pipe (66).

 (12)
 Loosen the pipe end-fitting (52) and disconnect the pipe (53) from the union (51).

 (13)
 Loosen the pipe end-fitting and disconnect the pipe (53) from the Blue power accumulator 2070GM. Remove the pipe (53).

 (14)
 Loosen the pipe end-fitting (2) and disconnect the tee-connector (1) from the union (3).

 (15)
 Remove the two nuts (42) and the two bolts (41).
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM HYDRAULIC POWER 液压3(20)