R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-42-16Page 414 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1 TASK 28-42-16-000-002
Removal of the Cadensicon 20QT
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific blanking caps No specific circuit breaker(s) safety clip(s) No specific safety barriers No specific warning notice No specific access platform 2.5 m (8 ft. 2 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
28-10-00-910-001 Safety Procedures When You Do Work in a Fuel Tank 28-10-00-910-002 Access to the Fuel Tanks and the Work Areas 28-25-00-650-001 Pressure Defuel 28-25-00-650-003 To Drain Remaining Fuel from the Wing Tanks and the
Center Tank 32-12-00-010-001 Open the Main Gear Doors for Access 57-17-11-000-001 Removal of the Covers 147AZ (148AZ) 28-42-16-991-002 Fig. 403
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-42-16Page 415 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
3. Job Set-up
__________ Subtask 28-42-16-941-055
A. Safety Precautions WARNING : OBEY THE SAFETY PROCEDURES WHEN YOU DO WORK IN A FUEL TANK.
_______
(1)
You must obey the fuel safety procedures (Ref. TASK 28-10-00-910-001) when you do work in a fuel tank.
(2)
Put the safety barriers in position.
(3)
Put a warning notice in position to tell persons not to operate the MLG doors.
Subtask 28-42-16-650-053
B. Fuel Configuration
(1)
Defuel the center tank (Ref. TASK 28-25-00-650-001).
(2)
Drain the remaining fuel from the center tank (Ref. TASK 28-25-00-650-003).
Subtask 28-42-16-010-051
C. Get Access
(1)
Open the applicable MLG door (Ref. TASK 32-12-00-010-001).
(2)
Make sure that the GROUND LOCK SLEEVE is installed on the applicable MLG door actuator.
(3)
Put the access platform in position below the applicable access panel 147AZ (148AZ).
(4)
Remove the applicable center-tank access panel 147AZ (148AZ) (Ref. TASK 28-10-00-910-002), (Ref. TASK 57-17-11-000-001).
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-42-16Page 416 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1 Subtask 28-42-16-865-053
D. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FUEL/FQI/CHAN/1 1QT A13 121VU FUEL/FQI/CHANNEL/1 AND 2 8QT L26 121VU FUEL/RFL/DFL/SPLY 2QU L24 121VU FUEL/RFL/DFL/XFR/DEFUEL/VALVE 1QU L23 121VU FUEL/FQI/CHAN/2 2QT M27
4. Procedure
_________
(Ref. Fig. 403/TASK 28-42-16-991-002)
Subtask 28-42-16-020-051
A. Removal of the Cadensicon 20QT
CAUTION : MAKE MATCH MARKS ON ALL THE ELECTRICAL WIRES BEFORE YOU
_______ DISCONNECT THEM. INCORRECT CONNECTION OF WIRES WILL CAUSE DAMAGE TO EQUIPMENT.
(1)
Disconnect the electrical connectors (4) from the cadensicon (1) and put blanking caps on the electrical connectors (4).
(2)
Remove the bolts (2) and the cadensicon (1) from the support bracket (3).
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-42-16Page 417 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
Cadensicon 20QT
Figure 403/TASK 28-42-16-991-002
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-42-16Page 418 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
TASK 28-42-16-400-002 Installation of the Cadensicon 20QT WARNING : MAKE SURE THAT THE FLIGHT CONTROL SAFETY-LOCKS AND THE WARNING
_______ NOTICES ARE IN POSITION.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM FUEL 燃油5(75)
