2RN3, 2RN4, 2RN5) AMM 23-51-12-400-001 Installation of the Audio Control Panel (ACP) (2RN1,
2RN2, 2RN3, 2RN4, 2RN5) AMM 23-51-34-000-001 Removal of the Audio Management Unit (AMU) (1RN) AMM 23-51-34-400-001 Installation of the Audio Management Unit (AMU) (1RN) AMM 27-92-41-000-001 Removal of the Side Stick Assembly 19VU (18VU) AMM 27-92-41-400-001 Installation of the Side Stick Assembly 19VU (18VU) ASM 23-11/02 ASM 23-51/02 ASM 23-51/03 ASM 23-51/04 ASM 23-51/06
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 051-099, 201-210, 301-399, 401-499, ∞∞23-11-00∞∞∞∞∞∞∞∞∞∞Page 218
Aug 01/05 CES
3. Fault Confirmation
__________________
A. Test
(1) Do the operational test of the HF system (Ref. AMM TASK 23-11-00-710-001).
NOTE : Do the transmission test for more than 60 s to see the ECAM
____ warning on the upper ECAM DU. (The COM HF 2 EMITTING message comes into view after 60 s of continuous transmission).
NOTE : Do this test at each crew station to find which station is
____
related with the failure.
NOTE : Do this test for the HF 2 system only.
____
NOTE : At the end of the test (before you do the fault isolation
____ procedure), make sure that these controls are not in the transmit position:
- the HF 2 transmission pushbutton switch on an Audio Control Panel
- a radio PTT switch on one of the two side sticks
- a radio PTT pushbutton switch
- a hand mike selector.
4. Fault Isolation
_______________
A. Table of the circuit breakers used in this procedure:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
R **ON A/C 051-099, 201-210, 301-399,
121VU COM NAV/HF2 1RE2 L13
R **ON A/C 051-099, 201-210, 301-399, 401-499,
B. After 60 s, when the HF 2 transmission stops, this ECAM warning does not go out of view:
- COM HF 2 EMITTING.
(1) If the above warning does not go out of view after action on the HF 2 transmission pushbutton switch (green bars off) (on the ACP of the related station):
- go to Para. 4.B.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 051-099, 201-210, 301-399, 401-499, ∞∞23-11-00∞∞∞∞∞∞∞∞∞∞Page 219
Aug 01/05 CES
(2) If the above warning goes out of view after action on the HF 2 transmission pushbutton switch (green bars off) (on the ACP of the related station):
- go to Para. 4.C.
C. Open the circuit breaker 1RE2 on the panel 121VU, then close it.
(1) If the fault continues:
- do a check for ground at the pin AB/2E of the HF 2 transceiver (3RE2) (Ref. ASM 23-11/02).
(a) If there is no ground signal at this pin:
- do a check and repair the wiring from HF 2 transceiver(3RE2) pin AB/2E to the first terminal block (Ref. ASM 23-11/02).
(b) If there is a ground signal at this pin:
- replace the XCVR-HF, 2 (3RE2) (Ref. AMM TASK 23-11-33-000-001) and (Ref. AMM TASK 23-11-33-400-001).
1 If the fault continues:
_
- replace the AMU (1RN) (Ref. AMM TASK 23-51-34-000-001) and (Ref. AMM TASK 23-51-34-400-001).
2 If the fault continues:
_
- do a check and repair the wiring between AMU (1RN) pin AA/5F and HF 2 transceiver (3RE2) pin AB/1C (Ref. ASM 23-51/06).
- go to Para. 4.D.
D. The fault is at one of the 3 crew stations.
(1) If the fault is at the Captain station:
- do a check of continuity between pin AA/9J and pin AA/9K of the AMU (1RN) (Ref. ASM 23-51/02).
(a) If there is continuity between the two pins:
- replace the SW-RAD PTT, CAPT (11RN) (Ref. AMM TASK 27-92-41-000-001) and (Ref. AMM TASK 27-92-41-400-001).
1 If the fault continues:
_
- replace the AMU (Ref. AMM TASK 23-51-34-000-001) and (Ref. AMM TASK 23-51-34-400-001).
2 If the fault continues:
_
- do a check and repair the wiring between AMU (1RN) pins AA/9J, 9K and pins 1, 2 of the radio PTT switch (11RN) (Ref. ASM 23-51/02).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320 Trouble Shooting Manual 排故手册 COMMUNICATIONS 通讯1(48)
