(12)
Remove the yoke pin (5) and the yoke (6) from the cylinder.
1EFF : ALL 1 52-13-14Page 403 1 1 Aug 01/99 1 1 1CES 1
Door-Damper and Emergency-Operation Cylinder
Figure 401/TASK 52-13-14-991-007
1EFF : ALL 1 52-13-14 Page 404
1 1 Feb 01/98
1 1
1CES 1
TASK 52-13-14-400-001
Installation of the Door-Damper and Emergency-Operation Cylinder
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
R No specific Torque Wrench : range 0.00 to 1.20 m.daN
R (0.00 to 9.00 lbf.ft) No specific Torque Wrench : range 0.20 to 3.60 m.daN
(2.00 to 26.00 lbf.ft) 98D52103003000 1 ADJUSTING TOOL - CYLINDER LENGTH
B. Consumable Materials
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
Material No. 19-010 USA AMS 5687
LOCKWIRE STAINLESS STEEL ANNEALED 0.8MM DIA
(Ref. 20-31-00)
C. Expendable Parts
-------------------------------------------------------------------------------
FIG.ITEM |DESIGNATION |IPC-CSN
-------------------------------------------------------------------------------
1 cotter pin 52-13-04 01B-010 18 cotter pin 52-13-04 01B-100
1EFF : ALL 1 52-13-14Page 405 1 1 May 01/05 1 1 1CES 1 D. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
25-23-46-400-002 Installation of the Door Linings at the AFT
Passenger/Crew Doors
52-10-00-010-001 Opening of the Passenger/Crew Door
52-10-00-410-001 Closing of the Passenger/Crew Door
52-10-00-860-001 Special Precautions before Work on the Passenger/Crew
Door
52-10-00-860-002 Special Precautions after Work on the Passenger/Crew
Door
52-13-14-200-001 Inspection/Check of the Damper and Emergency
Operation Cylinder of the Aft Passenger/Crew Door
52-13-14-220-001 Detailed Visual Inspection of the Mechanism of the
Door-Damper and Emergengy- Operation Cylinder
52-13-14-820-002 Adjustment of the Percussion Bellcrank Finger of the
Door Damper and Emergency Operation Cylinder of the
AFT Passenger/Crew Door
52-13-14-991-007 Fig. 401
3. Job Set-up__________
Subtask 52-13-14-860-056
A. Aircraft Maintenance Configuration
(1)
Make sure that the access platform is in position.
(2)
Make sure that the aft passenger/crew door is open (Ref. TASK 52-10-00-010-001).
(3)
Make sure that the special precautions are obeyed (Ref. TASK 52-10-00-860-001).
1EFF : ALL 1 52-13-14Page 406 1 1 Nov 01/00R 1 1 1CES 1
Subtask 52-13-14-865-068
B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU EIS/SLIDES/ARM AND WARN/FLT 15WN P11 121VU EIS/SLIDES/ARM AND WARN/GND 13WN P10 121VU EIS/SDAC1 AND 2/DOOR/DET/PAX 48WV P05
R Subtask 52-13-14-862-057
R C. Not Applicable
Subtask 52-13-14-220-053
R D. Preparation for Installation
(1)
Clean the component interface and/or the adjacent area.
(2)
Do an inspection of the component interface and/or the adjacent area.
(3)
Make sure that the parts retained from the removed component are clean and in the correct condition. (Ref. TASK 52-13-14-220-001)
4. Procedure
_________
Subtask 52-13-14-820-054
A. Adjustment of the Length of the Damper and Emergency-Operation Cylinder (Ref. Fig. 401/TASK 52-13-14-991-007)
(1)
Manually put the door damper and emergency-operation cylinder in the fully compressed position.
(2)
Make sure that the protrusion length J2 of the piston rod:
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM DOORS 舱门2(98)
