(4)
Assembly of the safety pin.
(a)
Install the washer (29), the caps (28) (27) and (26), the washer
(25) and the bolt (24).
(b)
Apply BONDING AND ADHESIVE COMPOUNDS (Material No. 08-007A) on the thread of the bolt (24) before installation.
(c)
Do not tighten the bolt (24). You must adjust the locking pin (30).
(5)
Connection of the rod (33).
(a)
Install the bushes (38) and (40) with SPECIAL MATERIALS (Material No. 05-002), the rod (33), the washer (42) and the bolt (41).
(b)
Install the washer (43) and the nut (44).
(c)
TORQUE the nut (44) to between 0.3 and 0.35 m.daN (26.54 and
30.97 lbf.in).
(d)
Install a new cotter pin (45). NOTE : If you install a new bolt (41), drill a hole of 1.9 mm
____ (0.0748 in.) for the cotter pin installation.
(6) Adjustment of the safety pin. (Ref. Fig. 415/TASK 52-11-21-991-014)
(a) With the door in the up position:
-make sure that the safety pin covers the shoulder of the bush on the fitting (56), and that the clearance J10 is 0 -0.3 +0.3 mm (0.0000 -0.0118 +0.0118 in.).
R 1EFF : 001-049, 051-056, 1 52-11-21Page 457 1 1 May 01/05 1 1 1CES 1
Safety Pin Adjustment Figure 415/TASK 52-11-21-991-014
1EFF : 1 1R 1CES ALL 1 11 1 52-11-21 Page 458 Feb 01/02
