• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-03-25 17:50来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 C. Flight Configuration Precautions
 (1)
 If the electrical power is not necessary for other maintenance tasks, de-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002). Then, it is not necessary to operate the LGCIU circuit breakers.

 (2)
 If the electrical power is necessary, do the precautions for flight configuration (Ref. TASK 32-00-00-860-001) before you open the LGCIU circuit breakers.


 1EFF : ALL 1 32-11-19Page 414 1 1 Feb 01/04R 1 1 1CES 1


 MLG Locksprings and Spring Expander Figure 402/TASK 32-11-19-991-005
 1EFF : 1 1R 1CES  ALL  1 11 1 32-11-19 Page 415 Feb 01/04

 

 Subtask 32-11-19-865-056
 D. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU L/G/LGCIU/SYS1/NORM 1GA C09 121VU HYDRAULIC/LGCIU/SYS2 2GA Q35 121VU HYDRAULIC/LGCIU/SYS1/GRND SPLY 52GA Q34
 Subtask 32-11-19-480-050
 E. Installation of the Spring Expander
 (1) Install the SPRING EXPANDER-MLG SIDE STAY (Ref. TASK 32-11-19-481-001).
 4. Procedure
_________ (Ref. Fig. 402/TASK 32-11-19-991-005) Subtask 32-11-19-020-054
 A. Disconnection of the lock springs (6) and (8)
 (1)
 Remove the cotter pin (13), the nut (12) and the washer (11). Discard the cotter pin (13).

 (2)
 Adjust the SPRING EXPANDER-MLG SIDE STAY by use of the driving nut (7), until the pin (2) is loose.

 (3)
 Remove these items together:

 -
the pin (2)

 -
the washer (10)

 -
the spacer (3)

 -
the washer (4).

 

 (4)
 Release the tension of the lock springs (6) and (8), by use of the driving nut (7).

 (5)
 Remove the SPRING EXPANDER-MLG SIDE STAY (Ref. TASK 32-11-19-081-001).

 (6)
 Remove the ground support and maintenance equipment, the special and standard tools and all other items.


 1EFF : ALL 1 32-11-19Page 416 1 1 Feb 01/04R 1 1 1CES 1


 TASK 32-11-19-400-003
 Connection of one end of the MLG Lock Springs to a MLG Side-Stay.
 WARNING : MAKE SURE THAT THE FLIGHT CONTROL SAFETY-LOCKS AND THE WARNING
_______
 NOTICES ARE IN POSITION.

 WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
 GEAR.

 CAUTION : WHEN YOU DO A MAINTENANCE TASK THAT USES COMMON GREASE, USE ONLY
_______ GREASES OF THE SAME SPECIFICATION (IT IS PERMITTED TO USE DIFFERENT BRANDS IF THEIR SPECIFICATIONS ARE THE SAME). DO NOT MIX GREASES THAT HAVE CLAY THICKENERS WITH GREASES THAT HAVE LITHIUM THICKENERS. THIS MIXTURE CAN CHANGE THE LUBRICATION PROPERTIES OF THE GREASE. IF YOU USE GREASES OF DIFFERENT TYPES (SPECIALLY THOSE WITH CLAY THICKENERS AND LITHIUM THICKENERS), DECREASE THE SERVICE INTERVALS OF THE AIRCRAFT (BY HALF, FOR EXAMPLE) SPECIFIED IN THE MAINTENANCE PLANNING DOCUMENT. DO THIS FOR APPROXIMATELY THREE OR FOUR SERVICES (REFER TO YOUR IN-SERVICE DATA TO FIND THE NUMBER OF SERVICES BEST ADAPTED TO YOUR AIRCRAFT).
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific safety barriers
 No specific warning notice
 No specific access platform 2.0 m (6 ft. 7 in.)

R No specific Torque Wrench : range 0.00 to 1.20 m.daN R (0.00 to 9.00 lbf.ft) 460005832 1 SPRING EXPANDER-MLG SIDE STAY
 1EFF : ALL 1 32-11-19Page 417 1 1 May 01/05 1 1 1CES 1 1EFF : ALL 1 32-11-19Page 418 1 1 Feb 01/05 1 1 1CES 1


 B. Consumable Materials
 -------------------------------------------------------------------------------
REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 04-004 Material No. 04-022 Material No. 09-016  USA MIL-PRF-23827 TYPE I SYNTH.ESTER BASED GREASE HIGH PRESSURE (Ref. 20-31-00)USA MIL-PRF-81322 GRADE 2 SYNTHE.HYDROCARBON GREASE HIGH PRESSURE (Ref. 20-31-00)USA MIL-PRF-81733D TYPE II CLASS B CORROSION INHIBITING FILLET CONSISTENCY (Ref. 20-31-00)
 C. Expendable Parts
 -------------------------------------------------------------------------------
FIG.ITEM |DESIGNATION |IPC-CSN -------------------------------------------------------------------------------
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM LANDING GEAR 起落架2(80)