(Ref. Fig. 402/TASK 32-11-16-991-002)
**ON A/C 001-003, 051-052,
(Ref. Fig. 403/TASK 32-11-16-991-005) R **ON A/C 004-049, 053-099, 101-149, 151-199, 201-299, 401-499,
(Ref. Fig. 403A/TASK 32-11-16-991-005-A)
**ON A/C 301-399,
(Ref. Fig. 403B/TASK 32-11-16-991-005-B)
1EFF : ALL 1 32-11-16Page 405 1 1 Aug 01/05 1 1 1CES 1
MLG Side-Stay Assembly - Removal/Installation
Figure 401/TASK 32-11-16-991-001
R 1EFF : 001-003, 051-052, 1 32-11-16Page 406 1 1 May 01/05 1 1 1CES 1
INTENTIONALLY BLANK
R 1 1
32-11-16Page 407
1 1 May 01/04 1 1 1CES 1
MLG Side-Stay Assembly - Removal/Installation
Figure 401A/TASK 32-11-16-991-001-A12 (SHEET 1)
R 1EFF : 004-049, 053-099, 101-149, 151-199, 1 32-11-16Page 408 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
MLG Side-Stay Assembly - Removal/Installation
Figure 401A/TASK 32-11-16-991-001-A22 (SHEET 2)
R 1EFF : 004-049, 053-099, 101-149, 151-199, 1 32-11-16Page 409 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1R MLG Side-Stay Assembly - Removal/Installation R Figure 401B/TASK 32-11-16-991-001-B12 (SHEET 1)
R 1EFF : 301-399, 1 32-11-16Page 410 1 1 May 01/04 1 1 1CES 1R MLG Side-Stay Assembly - Removal/Installation R Figure 401B/TASK 32-11-16-991-001-B22 (SHEET 2)
R 1EFF : 301-399, 1 32-11-16Page 411 1 1 May 01/04 1 1 1CES 1
MLG Side-Stay Assembly - Support Equipment Figure 402/TASK 32-11-16-991-002
1EFF : 1 1R 1CES ALL 1 11 1 32-11-16 Page 412 May 01/04
Cardan Joints - Dimensions
Figure 403/TASK 32-11-16-991-005
R 1EFF : 001-003, 051-052, 1 32-11-16Page 413 1 1 May 01/05 1 1 1CES 1
Cardan Joints - Dimensions
Figure 403A/TASK 32-11-16-991-005-A
R 1EFF : 004-049, 053-099, 101-149, 151-199, 1 32-11-16Page 414 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
R Cardan Joints - Dimensions
R Figure 403B/TASK 32-11-16-991-005-B
R 1EFF : 301-399, 1 32-11-16 Page 415
1 1 May 01/04
1 1
1CES 1
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
(Ref. Fig. 404/TASK 32-11-16-991-007)
**ON A/C 301-399,
(Ref. Fig. 404A/TASK 32-11-16-991-007-A)
**ON A/C 001-003, 051-052,
Subtask 32-11-16-020-052
A. Removal of the MLG Side-Stay Assembly
(1)
Remove the MLG actuating cylinder (Ref. TASK 32-31-46-000-001). Use a hoist that can lift 67.0 kg (147.7096 lb).
(2)
Disconnect the electrical connector of the cable (42) from the proximity sensor (32).
(3)
Remove the bolts (41), the washers (40) and the clips (39) from the bracket (38).
(4)
Put blanking caps on the disconnected electrical connectors.
(5)
Disconnect the hydraulic hoses as follows: WARNING : DO NOT GET THE FLUID ON YOUR SKIN OR IN YOUR EYES. IF YOU
_______
DO:
-FLUSH IT AWAY WITH CLEAN WATER
-GET MEDICAL AID. CAUTION : MAKE SURE THAT THE FLUID DOES NOT STAY ON THE AIRCRAFT
_______ STRUCTURE. IF THE FLUID GETS ON THE AIRCRAFT STRUCTURE, WASH IT OFF IMMEDIATELY WITH SOAP AND WATER.
(a) Put the container below the hose unions (20) and (31) and the hoses (25) and (26).
WARNING : CUT, REMOVE AND DISCARD THE LOCKWIRE AS YOU DO THE
_______ TASK. LOOSE LOCKWIRE CAN CUT OR BLIND YOU.
(b) Remove and discard the lockwire and disconnect the hose unions
(20) and (31) from the hoses (25) and (26).
1EFF : ALL 1 32-11-16Page 416 1 1 Aug 01/05 1 1 1CES 1
MLG Side-Stay Assembly - Circlip Detail
Figure 404/TASK 32-11-16-991-007
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 32-11-16Page 417 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
R MLG Side-Stay Assembly - Circlip Detail
R Figure 404A/TASK 32-11-16-991-007-A
R 1EFF : 301-399, 1 32-11-16 Page 418
1 1 May 01/04
1 1
1CES 1
(c)
Remove and discard the lockwire from the nuts (27), (30), (24) and (21).
(d)
Loosen the nuts (27), (30), (24) and (21).
(e)
Remove the nuts (21) and (30) and the washers (22) and (29), and remove the hoses (25) and (26) from the bracket assembly.
(f)
Remove the washers (23) and (28) and the nuts (24) and (27) from the hoses (25) and (26).
