__________________
Refer to the MPD TASK: 274100-04
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s)
No specific lint-free cloth
No specific access platform 2.8 m (9 ft. 2 in.)
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 04-004 USA MIL-PRF-23827 TYPE I SYNTH.ESTER BASED GREASE HIGH PRESSURE (Ref. 20-31-00)
1EFF : ALL 1 12-22-27Page 344 1 1 May 01/04R 1 1 1CES 1
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
20-24-11-100-001 Cleaning and Protection of the Cables 20-24-12-200-001 Check of the Control Cables SIL 12-008 12-22-27-991-008 Fig. 308
3. Job Set-up
__________ Subtask 12-22-27-865-074
A. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/THS/ACTR/MOT2 19CE2 B09 121VU FLIGHT CONTROLS/THS ACTR/MOT3 19CE3 Q17 121VU FLIGHT CONTROLS/THS ACTR/MOT1 19CE1 Q16
Subtask 12-22-27-010-057
B. Get Access
(1)
Put the access platform in position at the zone 312.
(2)
Open the access door 312AR.
4. Procedure
_________ Subtask 12-22-27-020-052
A. Removal of the Protective Covers
(Ref. Fig. 308/TASK 12-22-27-991-008)
(1)
Remove the screws (4) and the washers (3).
(2)
Release the fasteners (1) and remove the protective covers (2) and (5).
1EFF : ALL 1 12-22-27Page 345 1 1 May 01/04R 1 1 1CES 1
Removal/Installation of the Protective Covers.
Figure 308/TASK 12-22-27-991-008
1EFF : ALL 1 12-22-27 Page 346
1 1 May 01/04
1 1
1CES 1
Subtask 12-22-27-640-061
B. Lubrication of the THS Rear Cable (Area of Tension Regulator)
(1)
Make sure that the cables are not damaged (Ref. TASK 20-24-12-200-001).
(2)
Clean the control cable in this area with a lint-free cloth.
(3)
Make sure that there is no corrosion on the cables (Ref. TASK 20-24-11-100-001).
(4)
Lubricate the control cable with COMMON GREASE (Material No. 04-004). NOTE : Refer to the SIL (Ref. SIL 12-008) about the mixing of lithium
____
and clay based greases.
Subtask 12-22-27-420-052
C. Installation of the Protective Covers
(1)
Install the protective covers (2) and (5).
(2)
Tighten the fasteners (1).
(3)
Install the washers (3) and the screws (4).
5. Close-up
________ Subtask 12-22-27-410-057
A. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Close the access door 312AR.
(3)
Remove the access platform(s).
LANDING GEAR - SERVICING
________________________
TASK 12-22-32-640-001
Lubrication of the MLG and Doors
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU_______ START A TASK ON OR NEAR: - THE FLIGHT CONTROLS - THE FLIGHT CONTROL SURFACES - THE LANDING GEAR AND THE RELATED DOORS - COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING_______ GEAR.
R R R R R R R R R R R CAUTION : WHEN YOU DO A MAINTENANCE TASK THAT USES COMMON GREASE, USE ONLY_______ GREASES OF THE SAME SPECIFICATION (IT IS PERMITTED TO USE DIFFERENT BRANDS IF THEIR SPECIFICATIONS ARE THE SAME). DO NOT MIX GREASES THAT HAVE CLAY THICKENERS WITH GREASES THAT HAVE LITHIUM THICKENERS. THIS MIXTURE CAN CHANGE THE LUBRICATION PROPERTIES OF THE GREASE. IF YOU USE GREASES OF DIFFERENT TYPES (SPECIALLY THOSE WITH CLAY THICKENERS AND LITHIUM THICKENERS), DECREASE THE SERVICE INTERVALS OF THE AIRCRAFT (BY HALF, FOR EXAMPLE) SPECIFIED IN THE MAINTENANCE PLANNING DOCUMENT. DO THIS FOR APPROXIMATELY THREE OR FOUR SERVICES (REFER TO YOUR IN-SERVICE DATA TO FIND THE NUMBER OF SERVICES BEST ADAPTED TO YOUR AIRCRAFT).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM SERVICING 2(12)
