(2)
Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is on the flap/slat control lever in the cockpit.
(3)
Extend the No. 1 to No. 5 spoilers (Ref. TASK 27-60-00-866-002).
(4)
Make sure that a COLLAR-SAFETY, SPOILER is on the piston rod of each servo-control.
Subtask 12-22-27-865-064
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
Subtask 12-22-27-010-056
D. Get Access
(1)
Open the applicable MLG door (Ref. TASK 32-12-00-010-001).
(2)
Put the access platforms in position below the applicable access panels.
(3)
Remove the applicable access panels:
(a) For the LH wing, remove the following:
-193AB, 193BB
-573AB, 573BB, 573CB (Ref. TASK 57-51-37-000-002)
-575AB, 575BB, 575CB, 575DB, 575EB, 575FB, 575GB (Ref. TASK 57-51-37-000-004).
R 1EFF : 001-049, 051-061, 101-105, 201-203, 1 12-22-27Page 341 1 1 May 01/05 1 1 1CES 1
(b) For the RH wing, remove the following:
-194AB, 194BB
-673AB, 673BB, 673CB (Ref. TASK 57-51-37-000-002)
-675AB, 675BB, 675CB, 675DB, 675EB, 675FB, 675GB (Ref. TASK 57-51-37-000-004).
Subtask 12-22-27-020-051
E. Removal of the Flap Rotary Actuators
(1) Remove the flap rotary actuators (Ref. TASK 27-54-49-000-008):
-
actuator number 1, 6205CM(6255CM)
-
actuator number 2, 6211CM(6261CM)
-
actuator number 3, 6221CM(6271CM)
-
actuator number 4, 6233CM(6283CM).
4. Procedure
_________ Subtask 12-22-27-640-057
A. Regreasing of the Flap Rotary Actuators
(1) Refer to the applicable CMM and lubricate the rotary actuators:
-
for actuator 6205CM(6255CM) (Ref. CMM 27-53-23)
-
for actuator 6211CM(6261CM) (Ref. CMM 27-53-24)
-
for actuator 6221CM(6271CM) (Ref. CMM 27-53-25)
-
for actuator 6233CM(6283CM) (Ref. CMM 27-53-26).
5. Close-up
________ Subtask 12-22-27-420-051
A. Installation of the Flap Rotary Actuators
(1) Install the flap rotary actuators (Ref. TASK 27-54-49-400-005):
-
actuator number 1, 6205CM(6255CM)
-
actuator number 2, 6211CM(6261CM)
-
actuator number 3, 6221CM(6271CM)
-
actuator number 4, 6233CM(6283CM).
R 1EFF : 001-049, 051-061, 101-105, 201-203, 1 12-22-27Page 342 1 1 May 01/05 1 1 1CES 1 Subtask 12-22-27-410-056
B. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Install the applicable access panels:
(a)
For the LH wing, install the following:
-193AB, 193BB
-573AB, 573BB, 573CB (Ref. TASK 57-51-37-400-002)
-575AB, 575BB, 575CB, 575DB, 575EB, 575FB, 575GB (Ref. TASK 57-51-37-400-004).
(b)
For the RH wing, install the following:
-194AB, 194BB
-673AB, 673BB, 673CB (Ref. TASK 57-51-37-400-002)
-675AB, 675BB, 675CB, 675DB, 675EB, 675FB, 675GB (Ref. TASK 57-51-37-400-004).
(3) Close the applicable MLG door (Ref. TASK 32-12-00-410-001). Subtask 12-22-27-942-058
C. Removal of Equipment
(1)
Remove the safety barriers.
(2)
Remove the access platform(s).
(3)
Remove the warning notice(s).
(4)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
R 1EFF : 001-049, 051-061, 101-105, 201-203, 1 12-22-27Page 343 1 1 May 01/05 1 1 1CES 1 **ON A/C ALL
TASK 12-22-27-640-009 Lubrication of the THS Rear Cable (Area of Tension Regulator) WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE. WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM SERVICING 2(11)
