R 1EFF : 401-499, 1 31-60-00Page 519 1 1 Aug 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
1. On the panel 301VU (500VU):
-
set the PFD potentiometer to OFF.
-
set the PFD potentiometer to the center position.
Subtask 31-60-00-710-060
B. Manual PFD/ND Transfer
-the PFD is stopped and the PFD imagemoves to the ND.
-SELF TEST IN PROGRESS (MAX 40SECONDS) comes into view, then the ND image comes back on the PFD.
NOTE : This test is for to the CAPT side. For the F/O side, use the
____
indications between parentheses.
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the panel 301VU (500VU):
-
push then release the PFD/ND/XFR pushbutton switch.
-
push then release the PFD/ND/XFR pushbutton switch.
- on the PFD:
* the ND image comes into view. - on the ND:
* the PFD image comes into view.
-the PFD and ND images go to theirinitial position.
R 1EFF : 401-499, 1 31-60-00Page 520 1 1 Aug 01/05 1 1 1CES 1 Subtask 31-60-00-710-061
C. Manual ECAM/ND Transfer
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the center pedestal, on the
SWITCHING panel 8VU:
- set the ECAM/ND/XFR selector - on the lower ECAM DU:
switch to CAPT. * Message ECAM on ND, the system page
comes into view on the CAPT ND.
- set the ECAM/ND/XFR selector - on the lower ECAM DU:
switch to F/O. * message ECAM on ND and the system
page comes into view on the F/O ND.
- set the ECAM/ND/XFR selector - the DUs go to their initial
switch to NORM. configuration.
Subtask 31-60-00-710-062
D. Manual DMC 1 and 2 to DMC 3 Switching
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1.
On the overhead C/B panel 49VU: - open the circuit breaker 10WT1.
2.
On the center pedestal, on the SWITCHING panel 8VU:
-set the EIS DMC selector switch to CAPT/3.
3. On the panel 301VU:
-INVALID DATA message comes into view on the CAPT PFD and ND. - on the ENGINE WARNING image EIS DMC 1
FAULT message is displayed - on the glareshield:
* the MASTER CAUT lights come on.
-you can hear the single chime.
-INVALID DATA message goes out of viewand the DUs show their initial image.
R 1EFF : 401-499, 1 31-60-00Page 521 1 1 Aug 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
- push and release the PFD/ND/XFR - on the PFD and the ND, the images
pushbutton switch. change of position.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM 指示/记录系统 7(82)
