R 1. On the panel 121VU :
R - open the circuit breaker 2WV . - on the upper ECAM DU:
R * the FWS SDAC2 FAULT warning message
R comes into view.
R - open the circuit breaker 44WV. * the ELEC DC BUS2 FAULT warning
R message comes into view.
R - on the lower ECAM DU:
R * the ELEC page comes into view.
R - the single chime operates.
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
R R R
R R 2. On the CAPT and F/O glareshield panel:
R R - push then release the MASTER CAUT light.
R 3. On the panel 121VU :
R R R R R R - close the circuit breaker 44WV.
R R R R R - close the circuit breaker 2WV.
R 4. On the ECAM control panel:
R R R R R - push the CLR key to reset all warnings.
- on the CAPT and F/O glareshield panels 131VU and 130VU:
* the MASTER CAUT lights come on.
-the CAPT and F/O MASTER CAUT lights go off.
- on the upper ECAM DU:
* the ELEC DC BUS2 FAULT warning
message goes out of view. - on the lower ECAM DU:
* the ELEC page goes out of view and the DOOR/OXY page comes into view.
-On the upper ECAM DU:
* the FWS SDAC2 FAULT warning message goes out of view.
-after a some seconds, other caution messages can come into view.
- on the upper ECAM DU:
* the MEMO indication comes into
view. - on the lower ECAM DU:
* the DOOR page comes into view.
1EFF : ALL 1 31-50-00Page 542 1 1 Aug 01/05 1 1 1CES 1R Subtask 31-50-00-710-088
R B. Operational Test of the MASTER WARN lights
R -------------------------------------------------------------------------------R ACTION RESULT R -------------------------------------------------------------------------------
R 1. On the ENG/APU FIRE panel 1WD: R - push and hold the ENG 1(2) TEST R pushbutton switch. R R R
R R R R
R R R
R R R
R R R
R R R
R 2. On the ENG/APU FIRE panel 1WD:
R - release the ENG 1(2) TEST R pushbutton switch. R R R R On the ENG/APU FIRE panel 1WD:
- on the ENG 1(2) FIRE pushbutton switch, the FIRE legend comes on.
- on the ENG 1(2) AGENT 1 and AGENT 2 pushbutton switches, the SQUIB and DISCH legends come on.
On the ENG panel 115VU:
- on the ENG/1(2) FIRE/FAULT annunciator, the FIRE legend comes on.
After some seconds:
-
the continuous repetitive chime operates.
On the F/O and CAPT glareshield panels 130VU and 131VU:
-
the MASTER WARN lights flash.
On the upper ECAM DU:
-
the ENG 1(2) FIRE warning message comes into view.
On the lower ECAM DU:
-
the ENGINE page automatically comes into view.
-all the annunciator lights go off
-the continuous repetitive chime stops - on the upper ECAM DU, the warning message goes out of view
- on the lower ECAM DU, the ENGINE page goes out of view
1EFF : ALL 1 31-50-00Page 543 1 1 Aug 01/05 1 1 1CES 1 1EFF : ALL 1 31-50-00Page 544 1 1 Aug 01/05 1 1 1CES 1 OPERATIONAL PRESENTATION - DESCRIPTION AND OPERATION
R 5. Close-up________
R Subtask 31-50-00-860-094
R A. Put the aircraft back to its initial configuration.
R (1) Do the EIS stop procedure
R (Ref. TASK 31-60-00-860-002).
R (2) De-energize the aircraft electrical circuits
R (Ref. TASK 24-41-00-862-002).
____________________________________________________
**ON A/C 001-049, 051-099, 101-105, 151-199, 201-228, 301-302,
1. General
_______
The present section is an analysis of the faults which may occur on the aircraft systems.
In addition, this section describes the failures on an operational point of view. It gives the list of all the level 3, level 2, level 1 warnings, special lines and secondary warnings, status and memos sorted by priority order.
It also gives the presentation of a warning page and for each ATA chapter includes the following information:
-
the list of the warnings and the associated referenced figure for the level 3, level 2, level 1 warnings,
-
the associated ECAM system page (if any) displayed on the SD (names of symbols, colors and advisories),
-
the warning sequence of each fault with associated messages displayed on the ECAM Warning Display and the System Display.
R **ON A/C 106-149, 229-299, 303-399, 401-499, 中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址：A320飞机维护手册 AMM 指示/记录系统 6
