R C. Expendable Parts
-------------------------------------------------------------------------------
FIG.ITEM |DESIGNATION |IPC-CSN
-------------------------------------------------------------------------------
2 cotter pins 27-51-05 01 -100 2 cotter pins 27-51-05 01A-100
R D. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
from the External Power 27-50-00-866-008 Extension of the Flaps on the Ground 27-50-00-866-009 Retraction of the Flaps on the Ground 27-51-44-400-001 Installation of the Interconnecting Strut 27-54-61-000-002 Removal of the Flap Kink-Seals 27-54-61-400-006 Installation of the Flap Kink-Seals 29-10-00-863-001 Pressurize the Green Hydraulic System 29-10-00-863-002 Pressurize the Yellow Hydraulic System 29-10-00-864-001 Depressurize the Green Hydraulic System 29-10-00-864-002 Depressurize the Yellow Hydraulic System 29-14-00-614-001 Depressurization of the Hydraulic Reservoirs 31-32-00-860-006 Procedure to Get Access to the SYSTEM REPORT/TEST
F/CTL Page
31-60-00-860-001 EIS Start Procedure
31-60-00-860-002 EIS Stop Procedure
27-51-00-991-004 Fig. 502
3. Job Set-up
__________
(Ref. Fig. 502/TASK 27-51-00-991-004)
Subtask 27-51-00-941-052
A. Safety Precautions
(1)
Put the safety barriers in position.
(2)
Put the warning notices in position to tell persons not to operate the flight controls.
Flap Interconnecting Strut Figure 502/TASK 27-51-00-991-004
1EFF : 1 1R 1CES ALL 1 11 1 27-51-00 Page 539 May 01/04
Subtask 27-51-00-860-056
B. Aircraft Maintenance Configuration
(1)
Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
(2)
Get access to the flight controls (F/CTL) page on the MCDU (Ref. TASK 31-32-00-860-006).
(3)
Do the EIS start procedure (Upper ECAM DU and lower ECAM DU only) (Ref. TASK 31-60-00-860-001).
(4)
Move the flaps: WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE
_______ CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
(a) Extend the flaps to the 10 degrees position (slat and flap control lever position 1) (Ref. TASK 27-50-00-866-008).
(5)
Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER (98D27803000000) is on the flap/slat control lever.
(6)
Depressurize the Green and the Yellow hydraulic systems (Ref. TASK 29-10-00-864-001) (Ref. TASK 29-10-00-864-002).
(7)
Depressurize the applicable hydraulic reservoirs (Ref. TASK 29-14-00-614-001).
Subtask 27-51-00-865-057
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
1EFF : ALL 1 27-51-00Page 540 1 1 May 01/04R 1 1 1CES 1
Subtask 27-51-00-010-051
D. Get Access
(1)
Put the access platform in position below the wing at zones 580 and
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM FLIGHT CONTROLS 飞行操纵4(49)