• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-03-21 14:12来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

R (Ref. Fig. 606/TASK 27-54-00-991-033) R Subtask 27-54-00-941-064 R A. Safety Precautions R (1) Put the safety barriers in position. R (2) Make sure that the ground safety locks are installed on the landing
R gear (Ref. TASK 32-00-00-481-001).
R (3) Put the warning notice in position to tell persons not to pressurize R the hydraulic systems. R (4) Put a warning notice in position to tell persons not to operate the
R flight controls.
R 1EFF : 051-051, 1 27-54-00Page 625 1 1 May 01/05 1 1 1CES 1


R  Spherical Bearing - Inspection 
R  Figure 606/TASK 27-54-00-991-033 
R 1EFF :  051-051,  1  27-54-00 Page 626 
1  1  May 01/05
 1  1
 1CES  1

 

R  Subtask 27-54-00-860-069 
R  B. Aircraft Maintenance Configuration 
R  WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE_______ 
R  CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS 
R  AND/OR DAMAGE. 
R  (1) Extend the flaps fully (Ref. TASK 27-50-00-866-008). 
R  (2) Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER 
R  (98D27803000000) is installed on the flap/slat control lever. 
R  Subtask 27-54-00-865-070 
R  C. Open, safety and tag this(these) circuit breaker(s): 
R  -------------------------------------------------------------------------------
R  PANEL DESIGNATION IDENT. LOCATION 
R  -------------------------------------------------------------------------------
R  49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 
R  121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21 
R  Subtask 27-54-00-010-063 
R  D. Get Access 
R  (1) Put the adjustable access platform in position below the applicable 
R  flap track 1. 
R  4. Procedure_________ 
R  CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING_______ 
R  EDGE: 
R  - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS. 
R  - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS. 
R  - MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. 
R  INCORRECT INSTALLATION CAN CAUSE DAMAGE. 

R 1EFF : 051-051, 1 27-54-00Page 627 1 1 May 01/05 1 1 1CES 1


R  Subtask 27-54-00-210-056 
R  A. Inspection 
R  WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL_______ 
R  MATERIALS ONLY WITH A GOOD SUPPLY OF AIR. 
R  OBEY THE MANUFACTURERS INSTRUCTIONS. 
R  PUT ON PROTECTIVE CLOTHING. 
R  DO NOT GET THEM IN YOUR MOUTH. 
R  DO NOT SMOKE. 
R  DO NOT BREATHE THE GAS. 
R  THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. 
R  GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED. 
R  (1) At the flap track 1, clean: 
R  - the spherical bearing assembly (1) 
R  - the flap attachment fitting adjacent to the spherical bearing 
R  assembly (1) with MISCELLANEOUS (Material No. 19-003) and CLEANING 
R  AGENTS (Material No. 11-002), and let them dry. 
R  (2) Examine the spherical bearing installation at the flap track 1: 
R  (a) Use a flashlight and a mirror to examine the spherical bearing 
R  for signs of migration of the teflon liner (2). 
R  (b) If the teflon liner (2) has migrated between 50% and full 
R  migration, make an entry in the aircraft log book to replace the 
R  pendulum/bearing assembly (Ref. TASK 27-54-46-000-005) and 
R  (Ref. TASK 27-54-46-400-003), no later than the subsequent 
R  'A'check. 
R  5. Close-up________ 
R  Subtask 27-54-00-865-071 
R  A. Remove the safety clip(s) and the tag(s) and close this(these) circuit 
R  breaker(s): 
R  6CV, 8CV. 
R  Subtask 27-54-00-860-070 
R  B. Aircraft Maintenance Configuration 
R  WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE_______ 
R  CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS 
R  AND/OR DAMAGE. 

R 1EFF : 051-051, 1 27-54-00Page 628 1 1 May 01/05 1 1 1CES 1


R  (1) Remove the LOCKING TOOL - FLAP/SLAT CONTROL LEVER from the flap/slat 
R  control lever. 
R  (2) Retract the flaps fully (Ref. TASK 27-50-00-866-009). 
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM FLIGHT CONTROLS 飞行操纵4(164)