B. Do the test given in para. 3.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 051-099, 106-149, 151-199, 204-299, ∞∞34-36-00∞∞∞∞∞∞∞∞∞∞Page A236
301-399, 401-499, Aug 01/05 CES
TASK 34-36-00-810-871
Reset of the MMR2 after Initialization of the FMGC2
1. Possible Causes
_______________
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 34-36-00-740-003 BITE Test of the MMR
3. Fault Confirmation
__________________
A. Test Do the BITE test of the MMR (system 2) (Ref. AMM TASK 34-36-00-740-003).
B. Table of the circuit breakers used in this procedure:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
**ON A/C 051-061,
121VU COM NAV/MMR/2 42RT2 K09 R **ON A/C 062-099, 106-149, 151-199, 204-299, 301-399, 401-499,
121VU COM NAV/MMR/2 42RT2 L07 R **ON A/C 051-099, 106-149, 151-199, 204-299, 301-399, 401-499,
4. Fault Isolation
_______________
A. If the test gives the maintenance message
FMGC1(1CA1) BUS MMR/MMR2(40RT2):
Open and close after a short time the circuit breaker 42RT2.
B. Do the test given in para. 3.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 051-099, 106-149, 151-199, 204-299, ∞∞34-36-00∞∞∞∞∞∞∞∞∞∞Page A237
301-399, 401-499, Aug 01/05 CES
TASK 34-36-00-810-872
FM/GPS position disagree
1. Possible Causes
_______________
- FMGC-1 (1CA1)
- FMGC-2 (1CA2)
- MMR-1 (40RT1)
- MMR-2 (40RT2)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 22-83-34-000-001 Removal of the FMGC (1CA1,1CA2)
AMM 22-83-34-400-001 Installation of the FMGC (1CA1,1CA2)
AMM 34-36-31-000-002 Removal of the Multi Mode Receiver (40RT1, 40RT2)
AMM 34-36-31-400-002 Installation of the Multi Mode Receiver (40RT1,
40RT2)
3. Fault Confirmation
__________________ **ON A/C ALL R Post SB 34-1147 For A/C 001-004,051-060,
A. Test
- Not applicable, you cannot confirm this fault on the ground.
**ON A/C ALL
4. Fault Isolation
_______________ **ON A/C ALL R Post SB 34-1147 For A/C 001-004,051-060,
A. Do a check for a maintenance message on the POST FLIGHT REPORT (PFR).
(1) If there is a message and/or other warning than "FM/GPS POSITION DISAGREE" related to FMGC, GPSSU or MMR:
- refer to the related trouble shooting procedure in the applicable Page Block 101.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞34-36-00∞∞∞∞∞∞∞∞∞∞Page A238
May 01/05 CES
B. If there is no message and no other warning than "FM/GPS POSITION DISAGREE" on the PFR:
- replace FMGC-1 (1CA1) (Ref. AMM TASK 22-83-34-000-001) and (Ref. AMM TASK 22-83-34-400-001).
(1) If the NAV FM/GPS POS DISAGREE warning is still shown on the upper ECAM DU during next flight:
- replace FMGC-2 (1CA2) (Ref. AMM TASK 22-83-34-000-001) and (Ref. AMM TASK 22-83-34-400-001).
(a) If the warning is still shown during next flight:
- replace the MMR-1 (40RT1) (Ref. AMM TASK 34-36-31-000-002) and (Ref. AMM TASK 34-36-31-400-002).
1 If the warning is still shown during next flight:
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320 Trouble Shooting Manual 排故手册 导航 NAVIGATION 2(140)
